Do you have a question about the RD77760 and is the answer not in the manual?
Questions and answers
Summary of Contents for Jetlun RD77760
Page 1
Jetlun Zigbee Occupy Sensor User Guide User Guide rev 1.0 8 8 P A R K G R O V E D R I V E | S O S A N F R A N C I S C O | C A | 9 4 0 8 0 | U S A ...
Page 2
Jetlun Corporation. Jetlun Corporation reserves the right to make changes to this user’s guide at any time without notice and assumes no responsibility for its use. Jetlun products and services can only be ordered under the terms and conditions of Jetlun Corporation's applicable agreements.
Getting Additional Help To get information or assistance for problems that you encounter, please contact Jetlun Technical Support by emailing support@jetlun.com. Please always include with all inquiries the following information: •...
Jetlun Occupancy Sensor User Guide rev 0.1 DRAFT PRODUCT OVERVIEW Thank you for choosing the Occupancy Sensor (RD77760). The Occupancy Sensor is designed to communicate with JIM Gateway via Radio Frequency (RF) to provide remote control of your zigbee-enalbe device such as appliance module.
Jetlun Corporation Jetlun Occupancy Sensor User Guide rev 0.1 DRAFT Figure 1: Front Panel of the Occupy Sensor The Power LED lights up RED when the battery volume is low. The Detect LED lights up Green when some one stands in front of sensor.
Jetlun Corporation Jetlun Occupancy Sensor User Guide rev 0.1 DRAFT Table 3: Back Panel of the Occupancy Sensor Description The Zigbee Network button is applied for the Occupancy Sensor to join or leave the network. Press the Zigbee Network button once to join the network if the sensor is not in the network.
Jetlun Corporation Jetlun Occupancy Sensor User Guide rev 0.1 DRAFT INSTALLING THE JETLUN OCCUPY SENSOR Follow these quick steps to install your Jetlun Zigbee Occupy Sensor. Install the Occupy Sensor 3.1.1 Join the Network STEP 1: Press the Zigbee network button for 3-5 seconds and release the button.
Page 9
Jetlun Corporation Jetlun Occupancy Sensor User Guide rev 0.1 DRAFT STEP 3: Use the new battery instead the old one STEP 4: Close the bottom panel and screw the screw. 3 Q: Join the Occupancy sensor to the Gateway Zigbee network through RD75613?
Jetlun Corporation Jetlun Occupancy Sensor User Guide rev 0.1 DRAFT STEP 3: Occupancy sensor leaves the network Press and hold the Zigbee network button for 3-5 seconds. 2. The Occupancy Sensor has left the network successfully when the ACT LED is off.
Page 11
Glossary Zigbee is a low-speed, low powered 802.15.4 wireless mesh standard established by the Zigbee Alliance. The Zigbee Alliance is a non-profit Standard organization made up 300+ companies driving development of ZigBee wireless technology. For more information, visit www.zigbee.org. Zigbee is the only wirleess technology standard that has been listed under NIST as 1 of the 13 Smart Grid interoperability standards.
Need help?
Do you have a question about the RD77760 and is the answer not in the manual?
Questions and answers