Summary of Contents for uAvionix skyBeacon STC
- Page 1 skyBeacon Instructions for Continued Airworthiness and Maintenance Manual UAV-1002112-001 Rev A...
- Page 2 Corporation and may not be used without express permission of uAvionix. skyBeacon, Continuous Calibration, Power Transcoder, Echo Installer, and Ping Installer are trademarks of uAvionix Corporation and may not be used without express permission of uAvionix. skyBeacon technologies are patent pending.
-
Page 3: Revision History
1 Revision History Revision Date Comments 11/27/2018 Initial release UAV-1002112-001 Rev A... -
Page 4: Warnings / Disclaimers
2 Warnings / Disclaimers All device operational procedures must be learned on the ground. uAvionix is not liable for damages arising from the use or misuse of this product. This equipment is classified by the United States Department of Commerce's Bureau of Industry and Security (BIS) as Export Control Classification Number (ECCN) 7A994. -
Page 5: Limited Warranty
For the duration of the warranty period, uAvionix, at its sole option, will repair or replace any product which fails in normal use. Such repairs or replacement will be made at no charge to the customer for parts or labor, provided that the customer shall be responsible for any transportation cost. -
Page 6: Table Of Contents
4 Table of Contents Revision History ................... 3 Warnings / Disclaimers ................ 4 Limited Warranty .................. 5 Introduction ..................8 Publications .................. 8 Revision and Distribution .............. 8 Acronyms and Abbreviations ............8 System Description ................10 Features and Installation ............. 10 Interfaces .................. - Page 7 12 Support ....................18 Appendix A – Installation Record .............. 19 UAV-1002112-001 Rev A...
-
Page 8: Introduction
Owner/operators may obtain the latest revision of this document at www.uavionix.com or by contacting a uAvionix dealer. They may also register for updates and support at www.uavionix.com. 5.3 Acronyms and Abbreviations The following acronyms may be used in this document:... - Page 9 ICAO International Civil Aviation Organization Instrument Flight Rules Light Emitting Diode Maintenance Manual RTCA Radio Technical Commission for Aeronautics SBAS Satellite Based Augmentation System Supplemental Type Certificate Technical Standard Order Visual Flight Rules WAAS Wide Area Augmentation System Universal Access Transceiver UAV-1002112-001 Rev A...
-
Page 10: System Description
• LED status light that provides indication of proper operation This device transmits ownship Automatic Dependent Surveillance- Broadcast (ADS-B) data through the UAT data link. skyBeacon replaces an existing left wing-tip (red) position light. It must be installed as shown in the skyBeacon STC Installation Manual. UAV-1002112-001 Rev A... -
Page 11: Interfaces
6.2 Interfaces Aircraft Power (14/28V) Transponder Position Light Wi-Fi Breaker iOS/ Android YELLOW Anti-Collision Device Light Breaker BLACK Aircraft Ground 7 Control and Operation During normal operation, the pilot has no direct interface or control of the skyBeacon except for activating using the Position Light switch. Primary user interface controls are provided by the aircraft’s existing transponder, including selection of Mode A squawk code and IDENT. -
Page 12: Instructions For Continued Airworthiness
• Ground power source (capable of supplying sufficient power to the aircraft systems and avionics) • iOS or Android Mobile Device with “uAvionix skyBeacon Installer” • Dark glasses for viewing LEDs directly at close range • Optional or as required: Transponder ramp test set... -
Page 13: Maintenance Intervals
8.3 Maintenance Intervals Periodic checks of the skyBeacon system installed by the STC referenced in Section 5 are specified in Table 8-1 at specific intervals. Table 8-1 Maintenance Intervals Item Description/Procedure Section No. Interval Equipment Removal and On Condition Removal and installation of the skyBeacon Replacement... -
Page 14: Visual Inspection
8.4 Visual Inspection Perform a visual inspection as detailed in this section. Check skyBeacon system components for damage or other defects and replace as required. Inspection may require the temporary removal of a unit to gain access to connectors. Follow guidance in User and Installation Guide for equipment removal and replacement. -
Page 15: Altitude Encoder Testing
• Ensure transponder is turned OFF • Set the primary flight altimeter to 29.92 inches of mercury • Turn on the skyBeacon • Open the “uAvionix skyBeacon Installer” as detailed in skyBeacon User and Installation Guide Section 10 • Connect to skyBeacon •... -
Page 16: Post-Installation Test Procedures
9 Post-Installation Test Procedures Procedures that must be completed when the skyBeacon is removed and re-installed or replaced with a new unit are detailed in this section. Refer to skyBeacon User and Installation Guide Section 10.3 for Post- Installation Checks. If no other service is to be performed, continue to the return-to-service procedure in Section 10. -
Page 17: Return To Service Procedure
• Allow GPS up to 15 blinking On/Off and no position shown in app minutes to obtain position • Internal fault or other • Contact uAvionix Other fault - Annunciator LED configuration issue blinking or constant On and other error... - Page 18 • Any other applicable information related to the maintenance work performed on the aircraft. Appendix A includes an installation record that should be completed and updated as appropriate with every maintenance action. 12 Support For additional questions or support please visit: http://www.uavionix.com/support/ UAV-1002112-001 Rev A...
- Page 19 Appendix A – Installation Record A copy of this appendix must be used to record installation information and must be kept in the aircraft permanent records. skyBeacon Installation and Configuration Log Date: Aircraft Information Make: Model: Serial Number: Registration Number: skyBeacon Information Serial Number: Wi-Fi SSID:...