Subscribe to Our Youtube Channel
Summary of Contents for Elcon E-TRIP
- Page 1 ® ® Onboard Computer for Fleet Management Mounting Guidelines Version: 2004/08/16 Order No.: 9526 © ELCON Systemtechnik GmbH http://www.elcon-system.de...
- Page 2 Scope of supply 1) E-TRIP Onboard Unit 2) E-TRIP Operating Manual 3) Cable set 4) Built-in frame 5) Clamps 6) PSRR antenna 7) GPS antenna 8) GSM antenna 9) Driver card ® Page 2 E-TRIP Version: 2004/08/16 Order No.: 9526...
-
Page 3: Table Of Contents
3.7.1 LED Codes of Stella ST 2500.......19 Configuration of the Onboard Unit ....20 3.8.1 Setting of date and time........20 3.8.2 Setting of time zone........20 3.8.3 Check GPS function ........20 AGENCY INFORMATION ......21 DEALERS ............22 ® Page 3 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 4: Introduction
• OrbComm module (option) ® E-TRIP has been designed as a modular unit. You ® • E-TRIP Service Tool – the E-TRIP configuration can configure the unit according to your individual ® program that runs under MS Windows on your PC requirements. -
Page 5: Functions
Acceleration and gyro sensors for three axles are • check data, and ® important if you would like to use E-TRIP as accident data recorder (future implementation). • control engine, fuel consumption and efficiency. Digital input 0/12 V: storage and recall of the brake... -
Page 6: Statements
The use of the function ARO (Auxiliary Relay equipment generates, uses and can radiate radio ® Output) of the E-TRIP is not permissible in the frequency energy and, if not installed and used in member countries of the Economic Commission for accordance with the instructions, may cause Europe (ECE) to control the engine. -
Page 7: Installation
The detailed description of the installation is given in a separate document. This document is available from your vendor or service partner. 3.1 Antennas For the installation of the antennas for E-TRIP only the following two antennas are permissible: AEB 2400 for PSRR (DECT) Technical Data: Frequencies: 2.1/2.8 GHz UMTS-BLUETOOTH... -
Page 8: Maintenance
To clean the unit's front panel, use a clean cloth only. It should be soft, dust-laying and antistatic. Don't apply any cleaning agents, in order to prevent the surface from being damaged. Special cleaning measures or procedures are not required. ® Page 8 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 9: Connection Of The Device
D5 AUX_SER_TxD C5 ALARM_A B5 - A5 GND D6 AUX_SER_RxD C6 ALARM_B B6 SAE_J1708_A A6 (GND) D7 AUX_SER_DSR C7 ARO_A B7 SAE_J1708_GND A7 - D8 AUX_SER_DTR C8 ARO_B B8 SAE_J1708_B A8 - ® Page 9 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 10: Description Of Signals
B6 SAE_J1708_A: SAE J1708 Interface, Line A D4 – D8: see subchapter 3.4.6 B7 SAE_J1708_GND: SAE J1708 Interface, GND B8 SAE_J1708_B: SAE J1708 Interface, Line B B6 – B8: see subchapter 3.4.1 ® Page 10 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 11: Sae J1708 Interface
4) the engine speed and PTO status. With help of the PC program E-TRIP Service Tool it is possible to The inputs C1 ... C4 can be configured with help of the PC determine which input of the Onboard Unit shall be program E-TRIP Service Tool. -
Page 12: Digital Output
- Max. switching voltage: 220 V DC customized function. To use this function, it is necessary to enter a PIN upon setting the specific vehicle data set under E-TRIP Master. ® Page 12 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 13: Temperature Sensor
Onboard Unit. The vehicle position data can be sent only then if below smart cards: System Card and Workshop Card are not inserted und the E-TRIP Service Tool is not linked with the Onboard Unit. ®... -
Page 14: Installation Of The Onboard Unit
! Onboard Unit and other electronic systems of the vehicle. • E-TRIP shall be connected to the in-car outlets as recommended by the car manufacturer only through the cable set provided as part of the supply. - Page 15 Before connection : Please check carefully the wiring inside your vehicle. Improper wiring may cause not only damage to the device, but also cable fires or battery explosions. ® Page 15 E-TRIP Version: 2004/08/16 Order No.: 9526...
- Page 16 Connect the antenna cables (blue for GPS, violet for GSM, fawn for PSRR), until they noticeably snap in. Connect the cable trunks with the four plugs of different colours to the device, until they noticeably snap in. ® Page 16 E-TRIP Version: 2004/08/16 Order No.: 9526...
-
Page 17: Sim Card Installation
After this, insert the SIM card holder into the Onboard Unit as shown in figure 6, until the card holder snaps in. Make sure that the chip points to the top (cf. also figure 5). ® Page 17 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 18: Installation Of Orbcomm Modem (Option)
The bending radius of the antenna cable must not be less than 1 cm. 5. Link the Onboard Unit and the ORBCOMM Modem through chamber D with the modem´s 9-pole connection socket On-board voltage (SERIAL). ® Page 18 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 19: Led Codes Of Stella St 2500
( +V and – Ground ). After this, link the circular connector of the Orbcomm Modems (figure 7, PWR/BAT) and the battery with the modem. ® Page 19 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 20: Configuration Of The Onboard Unit
PC program you can enter the value of the local time zone. After this, check manual E-TRIP ServiceTool. the local time by leaving the menu (via button C), to display a driver information that would show time and date in the upper line. -
Page 21: Agency Information
Kelland International Ltd. China, Beijing 100020 Room 1512B, No. 22 Chao wai Street, Chaoyang District Phone: 0086 10 65 88 50 58 62 Fax: 0086 10 65 88 50 63 Mail: elcon@kellandinternational.com ® Page 21 E-TRIP Version: 2004/08/16 Order No.: 9526... -
Page 22: Dealers
Fax: +49(0) 41 35 / 80 07 37 Mail: info@BaTaLog.de GESTECH 2001 Canada, 478, St.-Hubert, Laval (Québec) H7G 2Y9 Phone: 001 450 629 23 76 Fax: 001 450 629 26 13 Mail: RenaldLabrie@AOL.com ® E-TRIP Version: 2004/08/16 Order No.: 9526... - Page 23 ® E-TRIP Version: 2004/08/16 Order No.: 9526...
- Page 24 D – 09232 Hartmanndorf Obere Hauptstrasse 10 Germany www.elcon-system.de ® E-TRIP Version: 2004/08/16 Order No.: 9526...
Need help?
Do you have a question about the E-TRIP and is the answer not in the manual?
Questions and answers