Page 1
LT6A - LT8A - LT10A LT12A- LT15A - LT215A Ac ve Loudspeakers USER MANUAL...
Page 2
FCC COMPLIANCE NOTICE This device complies with part 15 of the FCC rules. Opera on is subject to the following two condi ons: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired opera on. CAUTION: Changes or modif ca.
DIMENSIONS AND FLYING POINTS 20.4 cm 8.0" M4 Flying Point LT6A LT6 Pole adapter (supplied) 22.0 cm 8.7" M8 Flying Point LT8A Dual angle Moun ng Pole 34.0 cm 13.4" M10 Flying Point LT10A Dual angle Moun ng Pole...
Page 6
38.0 cm 14.9" M10 Flying Point LT12A Dual angle Moun ng Pole 44.8 cm 17.6" M10 Flying Point LT15A Dual angle Moun ng Pole 44.8 cm 17.6" M10 Flying Point LT215A Moun ng Pole...
LT10A / LT12A / LT15A / LT215A CONTROL PANEL (FIG.3) CONNECTIONS (FIG.4) tip - hot ring - cold cold sleeve - ground ground INPUT INPUT Jack (balanced) Balanced male XLR ground tip - hot cold cold ground INPUT LINK (output) Jack (unbalanced) Balanced female XLR *note: connect both cold and ground...
CONFIGURATIONS (FIG.5) basic conference system LT6A/LT8A/LT10A/ LT6A/LT8A/LT10A/ LT12A/LT15A/LT215A LT12A/LT15A/LT215A (mic in) single voice system (mic in) single voice system set this switch as “MIC” use preferably balanced cables stereo basic system 2x LT loudspeaker LEFT RIGHT LT6A/LT8A/LT10A/ LT6A/LT8A/LT10A/ LT12A/LT15A/LT215A LT12A/LT15A/LT215A...
SAFETY AND PRECAUTIONS CAUTION: before using this product read carefully the following safety instruc ons. Take a look of this manual en rely and preserve it for • future reference. When using any electric product, basic precau ons should always be taken, including the following: –...
CE CONFORMITY • Celectron products comply with direc ve 2004/108/EC (EMC), as stated in EN 55103-1 and EN 55103-2 standards and with direc ve 2006/95/CE (LVD), as stated in EN 60065 standard. • Under the EM disturbance, the ra o of signal-noise will be changed above 10dB. PACKAGING, SHIPPING AND COMPLAINT •...
Ring = - nega ve or "cold" Sleeve = shield or ground When connec ng an unbalanced signal (RCA pin jack inputs on LT6A model), wire them as follows: Pin2 / Tip = + posi ve or "hot" Pin 1-3 / Sleeve = shield or ground NOTE: whenever possible, use always balanced cables.
Page 13
7. HIGH control This control gives you up to 6 dB boost or cut at 8 KHz with a "SHELVING" curve shape. Use it to add or reduce the sound "clarity" and "brightness" (not available on LT6A model). 8. SIGN/LIMIT indicator GREEN LED illuminates to indicate the presence of the signal at the amplifi...
Page 14
Celectron Electronic Group BBFY Industrial USA Inc City of Industry - California www.celectronaudio.com...