Page 1
RMR-C410 Radar and Laser Detector Owners Manual SPECIFICATIONS:...
Page 2
Size: 1.4” x 3.0” x 4.4” Installation: The RMR-C410 detector is a full-featured radar and 1) Attach the windshield bracket to the C410 laser detector. detector. Align the edge on the bracket with the slot...
Page 3
3) Bend the windshield bracket mount to a level position. 4) The RMR-C410 will hang from the bottom of the bracket and must have an unobstructed view of the road ahead. 5) Insert the small end of the power cord gently into the power jack on the right side of the unit and the large end into the cigarette lighter receptacle.
Page 4
Dim: Press the Dim button for one second to dim the alarm lights. There are 3 levels of brightness. To brighten the alarm lights press the dim button again. Mute: Press the Mute button for one second to disable the alarm speaker for quiet operation. To reactivate the alarm speaker press the Mute button again for one second.
Page 5
VG- 2 will make you undetectable to radar. (Fig. C) Diagnostics: The RMR-C410 has a full internal automatic diagnostic system. If the power light goes off and remains off, check the 2-amp fuse in the power cord by unscrewing the silver tip and removing the fuse.
Page 6
Mute button for 3~5 seconds until the unit buzzes once. VG-2 is now off. Auto Memory: The RMR-C410 has an automatic memory. Any settings enabled when the unit is turned off will still be enabled when the unit is turned back on.
Page 7
The RMR-C410 is guaranteed against defects in The following accessories and parts are available: workmanship and materials for 36 months from the date of purchase. Should any malfunction occur, the Windshield mount $ 5.00 unit would be repaired or replaced by the factory at Suction Cups (set of 3) $ 2.00...
Page 8
Manufactured Exclusively by Rocky Mountain Radar in the USA...
Need help?
Do you have a question about the RMR-C410 and is the answer not in the manual?
Questions and answers