Funk-Electronic Piciorgros TMO-100 Setup And Configuration Manual

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!TMO%100!!!!!!!!!!!!!!!!!TMO%100!!!
Changes and Modifications
Any changes or modifications not explicitly approved by Funk-Electronic
Piciorgros GmbH as the responsible party for compliance could void the end
user's authority to operate the equipment.
Label on the backside of the TMO-100 (USA)
Label on the backside of the TMO-100 (Canada)
Funk%Electronic!Piciorgros!GmbH!
51149!Cologne!*!Germany!
www.tetramodem.com!
info@piciorgros.com
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!
Claudiastrasse!5!
!
!
!
! ! !
TMO-100 - Set-up and Configuration Manual
(Read before first operation)
TETRA Network Parameter:
Frequency Range: __________________
ISSI: __________________
MCC: __________________
MCN: __________________
COM-Port and AUX-Port Parameter :
Ethernet Port Parameter
Ethernet Port: Access to the embedded Web Server
Default IP-Address: 192.168.0.199
Default User Name: user (lower case)
Default Password: user (lower case)
Power Supply:
Left: Enclosure Ground (electrical earth)
Middle: + 12 Volt to + 24 Volt (+/- 20%)
Right: GND, 0 Volt from Power Supply
Quick Start Guide:
(1) Connect the TMO-100 to power Supply (12 or 24 Volt, electrical earth not
necessary for configuration)
(2) PWR LED and OK LED should be on, if OK flashes please refer to the
Technical Manual.
(3) If the device is not yet configured to your TETRA Network, a yellow LED
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !