Status Monitor Messages; System Error Messages - SmartDisk FlashPath Secure Digital Memory Card User Manual

Using FlashPath

Status Monitor Messages

Status Monitor Messages pop-up automatically when you position your cursor over the
Status Monitor icon.
Diskette Mode
Normal Operation
Battery Low
Battery Critical
Sleeping
Missing Secure
Digital Memory
Card or
MultiMediaCard

System Error Messages

System Error Messages automatically appear when an error condition exists.
Sleeping
No Media
Message
No FlashPath with a Secure Digital
Memory Card or MultiMediaCard in Drive
Computer able to read and write to
FlashPath
Writes - disabled (If you are currently
performing a write, FlashPath will try to
complete the write.) Reads - enabled
Reads - disabled
Writes - blocked
Note: Flashpath will attempt to complete
the current write.
Device has entered sleep mode to
conserve batteries
Reads and Writes - disabled.
Secure Digital Memory Card or
MultiMediaCard not detected in
FlashPath.
Message
The FlashPath has gone to sleep.
There is no Secure Digital Memory Card or
MultiMediaCard in the FlashPath.
Condition
Insert Secure Digital Memory Card or
MultiMediaCard into FlashPath and
insert FlashPath into the drive.
None.
Let the computer complete reads or
write; replace batteries.
Replace both batteries immediately.
Eject, wait awhile, and reinsert
FlashPath.
Eject FlashPath. Check for Secure
Digital Memory Card or
MultiMediaCard. Check that Secure
Digital Memory Card or
MultiMediaCard is inserted correctly.
Reinsert FlashPath.
Condition
Corrective Action
Corrective Action
Eject, wait awhile, and reinsert
FlashPath to activate.
Eject FlashPath. Check for
Secure Digital Memory Card or
MultiMediaCard. Check that
Secure Digital Memory Card or
MultiMediaCard is inserted
correctly. Reinsert FlashPath.
FlashPath User Guide
•
•
•
10
•
•
•