Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Blackbox GO!
Summary of Contents for Blackbox GO!
-
Page 2: Charging The Battery
GO!® Quick Start: Perform the following steps to assemble your handheld radio: Charge the battery. Install the battery. Install the antenna. Install the belt clip. Turn on the radio. Select a channel. Install your audio accessory (if needed). ... -
Page 3: Adjusting The Volume
Installing an Audio Accessory Remove the protective cover on the side of the radio and plug in your earpiece or headset. Adjusting the Volume Turn the volume knob clockwise to turn up the volume. To turn down the volume, turn the knob anticlockwise. Be careful if you are wearing an audio accessory! Radio Control Please read the following carefully:... -
Page 4: Programmable Buttons
Programmable Buttons Your agent can set a programmable button to a shortcut button for a function or channel or call group in accordance with the duration for which the button is pressed: • Press: means pressing a button and immediately releasing the button. Note: This radio can’t press and hold the buttons to change the function. -
Page 5: Led Indicator
LED Indicator The LED indicator indicates operation of the radio. • If the indicator is lit red, it indicates that the radio is transmitting signals, send messages, encryption calling or data. • If the indicator is lit green, it indicates that the radio is being turned on, or receiving a call, messages, encryption calling or data. - Page 6 Select a Channel, a User ID, or a Call Group ID After selecting a zone (if there are multiple zones), you can turn the channel selection knob to select a channel, a user ID, or a call group ID. Receive and Respond to a Call After selecting a channel, a user ID, or a call group ID, you can receive or respond to a call.
- Page 7 Initiate a Call with the Channel Selection Knob Initiate a Group Call To initiate a group call, you must join a call group on the Radio. Perform the following steps: Turn the channel selection knob, and use an activated call group ID for selecting a channel. Hold the Radio vertically, and keep it about 2-6 inches away from your mouth.
-
Page 8: Advanced Functions
Advanced Functions You can use the following advanced functions: TDMA DMO 2 time slots Scan list… Scanning… SMS… Set the power level Talk around Remote monitor Remote alarm Remote kill TDMA DMO (Direct mode operation) 2 times slots DMO 2 times slots will make one frequency point which can be used for two channels at the same time. It will save the frequency resources. -
Page 9: Talk Around
When the Radio detects an active channel The Radio stops at the detected active channel or call group. The Radio stays on this channel for a pre-programmed duration call "idle time". Perform the following steps: Within idle time, hold the Radio vertically, and keep it about 1 to 2 inches (2.5 to 5.0 cm) away from your mouth.
Need help?
Do you have a question about the GO! and is the answer not in the manual?
Questions and answers