Advertisement
Table of Contents
CLiK64-T User Instructions
1.
Press the button on the key tag transmitter for at least one
second to transmit the signal code. A red indicator light will
flash for the duration of the transmission. Pressing and
holding the button down only transmits one pulse. This
reduces unintentional transmissions and conserves battery
life.
2.
Release and press the button for one second again to send
another transmission.
3.
If the light on the transmitter does not light up when you
press and hold any button, replace the battery.
CLiK64-T-P1
CLiK64-T-P3
CLiK64-T-P2
CLiK64-T-P4
1
Advertisement
Table of Contents
Summary of Contents for Active Secure CLiK64-T series
- Page 1 CLiK64-T User Instructions Press the button on the key tag transmitter for at least one second to transmit the signal code. A red indicator light will flash for the duration of the transmission. Pressing and holding the button down only transmits one pulse. This reduces unintentional transmissions and conserves battery life.
- Page 2 CLiK64-T Battery Replacement Carefully pry open the case with a flat edge tool or screwdriver from the key ring corner. Make sure the case is laid flat on the table upside down. Push the coin shaped battery out of its holder and replace it with a CR2032 battery being careful to place the “+”...
- Page 3 CLiK64-T Label Placement Place label in outlined area...
- Page 4 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation This device complies with Industry Canada licence-exempt RSS standard(s).
Need help?
Do you have a question about the CLiK64-T series and is the answer not in the manual?
Questions and answers