Table of Contents
Advertisement
2.1.2 Modbus disable
Set this position to on to disable the modbus functionality. This will result in the unit to
disable any meter protocol and enter the transparent mode.
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
2.1.3 Meter type
This selects the meter type, valid settings are:
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
3. Device modes
3.1 Program mode
Program mode is entered when all dip switch positions are set to the on position.
ON
1 2 3 4 5 6 7 8
The program mode command interpreter will listen on the RS232 port (RJ12) at 9600
baud, no parity and one stop bit.
A USB dongle available from Camax UK may be used to gain access to the RS232 port.
3.1.1 Command set
Typing help at the command line displays the available commands, these are: METER,
RS232 and RS485.
Modbus enabled
Modbus disabled
A1140
A1700
Page 4
Advertisement
Table of Contents
