We are pleased to have you as a valued customer and hope you will be delighted with your TRAXX. This manual provides all the information you need for putting the TRAXX to work for you. TRAXX WINDSHIELD BRACKET & SUCTION CUPS Note: Always obey all local and federal laws when using this device to measure the performance of your vehicle.
CONTROL AND BUTTONS INSTALLATION For the best performance of acceleration features, mount TRAXX on the windshield centered between driver and passenger. TRAXX must be positioned straight across the vehicle. Do not angle the device toward the driver. The front of the device does not have to be perfectly level.
Page 5
To turn on the TRAXX, connect power and rotate the wheel controller, located on the side of the device, until you hear it click.
�SET-UP FOR METRIC USE �TRAXX can measure the followings: You can set up your TRAXX for US or Metric unit and calculate engine power in HP or PS (metric horsepower). When pressing 1. Time to go from 0 to 60MPH (0 to 100Km) ‘DOWN’...
Page 7
The setup item HP MIN SPEED sets the speed that the TRAXX Press the UP or DOWN button until the correct weight is starts measuring horsepower. The setup item HP MAX SPEED shown.
0-60 Mile mode or 1/4 Mile mode. calibration. After the calibration is completed successfully, its If the TRAXX receives Radar or Laser signal when it is in display shows 'READY' with blinking: accelerometer operation, it stops measurement and gives Radar or Laser warning.
Page 9
Pressing the UP or DOWN button once causes the display to Pressing the UP or DOWN button causes the display to show show average horsepower between the two speeds chosen in average horsepower between the two speeds chosen in setup. setup.
Press MODE button to select G Force mode or 0-60 Mile mode or 1/4 Mile mode in ACCELEROMETER mode. a. The TRAXX displays safety mode on/off: ‘SA ON’ or ‘SA OFF’ �START BUTTON b. Select ‘SA ON’ or ‘SA OFF’ by using UP/DOWN buttons.
Press START button to turn on/ off the backlight at Radar �RADAR/ LASER ALERT DISPLAY Detector mode. When TRAXX receives each Radar, Laser and VG-2 signal, it displays a detection band with voice alarm. The signal strength �VG-2 SELECT level of Radar is displayed as follows.
TROUBLESHOOTING �TEST MODE If the device does not turn on: Hold down UP button for three seconds, the TRAXX will demonstrate how it operates when each radar and laser signal is detected. 1. Check the power cord. Be sure all power connectors are properly installed.
LASER SCRAMBLER SELECT FEATURE MEMORY a. Hold down "CITY" button and turn on the TRAXX to select The TRAXX will automatically remember your settings when laser scrambler on/off. the unit is turned off or removed from the power. All features selected are retained in memory.
FACTORY RESET SPECIFICATIONS Press DOWN button for five (5) seconds to enter Factory RADAR Reset. When the display is blinking ‘RESET’, press START Receiver Type: Dual conversion superheterodyne button to reset all data to factory default. If you do not want Antenna Type: Linear polarized.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. SERVICE If you wish to return the TRAXX, please contact KAT Inc. Phone: (915) 533-1335 Fax: (915) 533-1344...
Need help?
Do you have a question about the Traxx and is the answer not in the manual?
Questions and answers