Creating A Sequence - Parallax 28823 User Manual

Creating a Sequence

Creating a sequence is easy. The following example shows you how to create a simple sequence.
Click on the 500 position for servo channel 0 and edit the delay for that channel to 500mS as shown.
Click the red circle (Record) to record the frame. Note: clicking the record button on the last frame of a
sequence caused the current frame to be copied to the next frame (this helps with animation sequences).
If you were to click the record button after editing an existing frame, the current frame would be
updated, and the next frame would not be disturbed.
Click the number 2500 for channel 0 and click the record button again.
Click the number 500 for channel 0 and click the record button again.
Click the number 1500 for channel 0, increment the Go to number to 0 and click the record button.
That completes one simple animation sequence. Now you may use the CD-like control buttons to run,
stop, and pause your animation sequence.
To save your sequence, simply click on Sequence->Save and specify a file name.
To retrieve your saved sequence, simply click on Sequence->Open and specify the filename.
Parallax, Inc. • Parallax Servo Controller USB – Rev B ver 3.4 (#28823) • 8/2006 7