Connections; Notes On Connections; Using One Ys-W270/W270P - Sony YS-W270 Operating Instructions Manual

Connections

Notes on Connections

• This unit will only operate when connected to a Sony
SSC-series camera or the SPT-M320/M320CE video
camera with multiplex transmission capability. When
making the connections, refer also to the operation
manual for the connected video camera module.
If you connect the unit to an older model of the SSC series,
please contact your Sony dealer.
• Turn off the power to all the equipment while making
the system connections. If you connect a camera to
this unit after switching the power on, the camera will
not be supplied with power.

Using One YS-W270/W270P

Using one YS-W270/W270P you can set up a system
of up to four cameras, with two monitors for each
camera.
[SYNC MODE:
PRIMARY]
(Front)
Camera
4
3
2
1
10
(GB)
to video input
connector
to CAMERA
IN 1 to 4
to video input
to DC IN. VS IN/
connector
VIDEO OUT
Video signal flow
• The cables connecting this unit to the video cameras
carry the power supply and synchronization signal in
addition to the camera video output signal. It is
therefore not possible to add a booster or other device
between the unit and a camera.
• Always use a 75-ohm coaxial cable of the length
specified in the tables on page 8 (GB) when connecting
a video camera to this unit; use of an incorrect cable can
lead to camera malfunction. Also be sure to set the cable
compensation switch correctly.
Make all the connections before setting the POWER
switch of this unit to ON.
Video monitor
Picture from camera 4
Picture from camera 3
Picture from camera 2
Picture from camera 1
to VIDEO
OUT A 1
to 4
75Ω: ON
YS-W270/W270P
75Ω
to VIDEO
to an AC outlet
OUT B 1
to 4
Video monitor
Picture from camera 1
Picture from camera 2
Picture from camera 3
Picture from camera 4