Channel Set; Auto Channel Memory - Samsung DVD-VR300 Instruction Manual

Setting Up the Parental
Control
6 Select Rating Level you want using ❷
buttons, then press the ❿ or ENTER but-
ton.
• For example, if you select up to Level 6,
discs that contain Level 7, 8 will not play.
Larger number indicates the program is
more intended to adult use only
Press the RETURN or ➛ button to return
to the previous menu. Press the MENU
Note
button to exit the menu.
See Troubleshooting page if you forget
your password.
About the Change Password;
1 Select Change Password using ❷ buttons,
then press the ❿ or ENTER button.
• The 'Enter the password.' message will be
displayed.
Enter the 4-digit password using the 0 to 9
2
buttons on the remote.
• The 'Confirm the password.' message will
be displayed.
38 - System Setup
3 Enter your password again using the 0 to 9
buttons on the remote.
➛
Press the RETURN or button to return
to the previous menu. Press the MENU
Note
button to exit the menu.

Channel Set

This feature allows you to manually set the DVD
Recorder-VCR-VCR' s tuner band to Antenna or
Cable, whichever you connected to the Antenna In
jack during initial setup.
• Use this setting only if Auto Setup detected the
incorrect tuner band, i.e. channels are coming
in on the wrong channel numbers.
1 Open "MENU"
With the DVD in Stop or Play mode, press
the MENU button.
Select "Setup"
2
Using the UP/DOWN buttons, move the
selection bar to "Setup" then press ENTER
to select.
Select "Channel Set"
3
Using the UP/DOWN buttons, move the
selection bar to "Channel Set", then press
ENTER to select.
Channel Set
Select "Antenna/Cable TV"
4
Move the selection arrow to "Antenna/Cable
TV" then press right button to select from
the following options:
• Antenna - Indicates that the DVD
Recorder-VCR-VCR is connected to an
indoor or outdoor VHF/UHFantenna.
• Cable TV - Indicates that the DVD
Recorder-VCR-VCR is connected to Cable
TV .
• Cable TV - Indicates that the DVD
Recorder-VCR-VCR is connected to Cable
TV .

Auto Channel Memory

Auto Channel Memory will automatically seek and
store all active channels in your area.
Open "MENU"
1
With the DVD in stop mode, press the
MENU button.
Select "SETUP"
2
Using the UP/DOWN buttons, move the
selection bar to "Setup" then press ENTER
to select.
3 Select "Channel Set"
Using the UP/DOWN buttons, move the
selection bar to "Channel Set", then press
ENTER to select.
4 Run "Auto channel memory"
Move the selection arrow to "Auto Channel
Memory," then press ENTER to select.
• The DVD Recorder-VCR-VCR will auto-
matically search for all available channels
in the selected Tuner Band. This procedure
may take a few minutes to complete.
• When finished, the lowest channel found
will be displayed.
• Press ENTER button to STOP or cancle scanning.
System Setup - 39