StarTech.com BOX4MODULE Quick Start Manual

Docking Station Module BOX4MODULE | BEZ4MOD

Product Design

Actual product may vary from photos
Front View
LED
Indicator
Power
Button
USB-A
Port
Rear View
Speaker Out
Port
DC
20V 6A
Port
RJ45
Port

Package Contents

• Docking Station Module x 1
• Universal Power Adapter x 1
• Power Cords (NA / UK / EU) x 3
• USB-A to USB-B Cable x 1
• USB-C Cable x 1
• Mounting Bracket x 1
• Bracket Screws (M5 x 20 mm) x 4
• Module Screws (#6-32 x 3/16) x 8
• Quick-Start Guide x 1
For the latest information, specifications, and support visit www.startech.com/MOD4DOCKACPD
HDMI
In Port
USB-B USB-C
Port Port
HDMI HDMI
Mic In
IN OUT
Port Port Port
USB-A
Ports

Requirements

For the latest requirements and full product manual, please visit
www.startech.com/MOD4DOCKACPD.

Installation

Note: StarTech.com is not responsible for any damages related to
the installation of this product.
See the Installation section in the Modular Table Box
(BOX4MODULE) or Single Module Table Box (BEZ4MOD) User
Manual for instructions on how to install a module into a table
surface.

Mounting Installation

Installation Requirements:
• Mounting Bracket x 1
• Bracket Screws (M5 x 20 mm) x 4
• Module Screws (#6-32 x 3/16) x 8
• Writing Utensil x 1
• Phillips Head Screwdriver x 1
Note: Before mounting the Module, consider the desired position
of the ports (top and bottom) as it will affect the mounting
orientation.
1. Align the Mounting Bracket with four of the Mounting Holes
on the Module.
Note: The Module has four Mounting Holes on each side on the
Module, which gives you two different mounting options.
2. Insert the Bracket Screws (x4) through the Mounting Bracket
and into the Mounting Holes.
3. Tighten the Mounting Screws using a Phillips Head
Screwdriver, be careful not to overtighten.
4. Before installing the Mounting Bracket, measure and position
the Mounting Bracket in the desired location. The Module can
be mounted on a vertical or horizontal surface.
Note: Depending on the surface you are using to install the
product, you may need to drill pilot holes prior to installing the
screws into the surface.
5. Mark the location of the Mounting Holes using a Writing
Utensil. These marks can be used as a guide to indicate where
the Mounting Screws will be installed in the surface.
6. Install the Bracket Screws (x4) through the Mounting
Bracket and into the mounting surface, using a Phillips Head
Screwdriver. Be careful not to overtighten.
Warning: To prevent the Mounting Screws from penetrating
the opposite side of the installation surface, be conscious of
the size of the Mounting Screw compared to the depth of the
surface.
Quick-Start Guide
SKU #: MOD4DOCKACPD
Manual Revision: 11/09/2018