Advertisement
REGISTER THIS PRODUCT WITH PHILIPS SELECON: www.seleconlight.com/warrantyreg
A safety chain (Order Code: 20SC) MUST always be used when rigging fixtures on bars, ladders etc.
The safety chain is passed through the fixture anchor point hole located at the rear of the fixture and
around the bar. Be careful to allow sufficient slack to allow the fixture to be focused freely. Selecon
supply a safety chain with all theatrical / entertainment fixtures.
The fixture should be at least 6 ft away from the nearest object it is lighting.
YOKE AND PIVOT POINT
The yoke can be positioned anywhere in the channel that runs the length of the fixture. This is useful to
achieve the best balance if using a color changer or other accessory mounted on the front of the fixture, or to
fit the fixture in space restricted positions.
The yoke balance point is factory set on the lens tube for normal applications. To move the yoke, loosen the
M8 bolts at the bottom pivot point of the yoke on each side of the fixture. Slide the yoke to the required
position, check the yoke is evenly positioned on each side and tighten the M8 bolts.
FOCUSING
The variable beam focus position of the Arena range is altered by adjusting the lamp/
reflector position in relation to the front lens. Finger tight pressure only is necessary to
lock the lens off in their chosen positions. A reference scale is provided to record
settings.
Please note that the handles on the Arena range can reach high temperatures
depending on the position or orientation of the fixture, and that gloves should always be worn when
focusing these fixtures.
PAN AND TILT ADJUSTMENT
To pan your fixture loosen the top suspension nut and adjust, then retighten. To tilt, loosen the locking clamp
handle on the side of the fixture, tilt and retighten finger tight.
ACCESSORIES
Safety Chain (Order Code:20SC)
Lens Safety Mesh (Order Code: 20SM24)
Color Frame - the fixture is supplied with a color frame. Additional color frames are available (Order
Code: 20CFSF2020 )
Barndoors – 20BDSF2020
CLEANING
Open the down –swinging door, and clean the lens and or reflector with a soft lint free cloth.
This is the only maintenance task that can be safely carried out by non-approved personnel. Refer below –
Safety & Maintenance note.
SAFETY & MAINTENANCE
Philips Selecon has manufactured this fixture in accordance with recognised best practices to recommended
international safety standards. It is your responsibility to maintain this fixture in good & safe working condition.
Repairs should only be carried out by suitably qualified persons. Do not operate the fixture with cracked lens,
damaged cable, etc. Consult your Philips Selecon distributor for assistance. Only replace damaged parts
with authorised Philips Selecon spares.
Version 4: October 2010
Advertisement
