Advertisement
Advertisement
Table of Contents
Related Manuals for YUNEEC ST10+
Summary of Contents for YUNEEC ST10+
-
Page 2: Battery Warnings And Usage Guidelines
BATTERY WARNINGS AND USAGE GUIDELINES WARNING: Lithium Polymer (LiPo) batteries are significantly more • When charging, transporting or temporarily storing the LiPo battery the volatile than alkaline, NiCd or NiMH batteries. All instructions and temperature range should be from approximately 40–120° F (5–49° C). Do warnings must be followed exactly to prevent property damage and/or not store the battery or aircraft in a hot garage, car or direct sunlight. -
Page 3: Charging The Batteries
ST10+ OVERVIEW CHARGING THE BATTERIES WARNING: Lithium Ion (LiIon) and Lithium Polymer (LiPo) batteries are significantly more volatile than alkaline, NiCd or NiMH batteries. All instructions and warnings must be followed exactly to prevent property damage and/or serious injury as the mishandling of LiIon/LiPo batteries can result in fire. - Page 4 IMPORTANT NOTE: Streaming video from the CGO2+ to the ST10+ and to a separate phone/tablet (or another Yuneec transmitter/personal ground station) at the same time is NOT recommended as it will result in a very significant lag in the video downlink.
-
Page 5: Taking Photos And Recording Video
TAKING PHOTOS AND RECORDING VIDEO The ST10+ seamlessly integrates control of the CGO2+ so you can easily The slider located on the left side of the ST10+ allows you to set the take still photos and start/stop video recording using the corresponding pitch/tilt position of the CGO2+ from approximately straight ahead (when buttons located on top: the slider is in the uppermost position) to approximately straight down... -
Page 6: St10+ And Receiver Binding
ST10+ AND RECEIVER BINDING Step 1) Turn on TYPHOON, and Step 5) Tap the ‘Flight after the Main LED Status Indicator Settings’ button, begins to flash blue rapidly, lift the required press ‘OK’ 2 x 45+° back end upward approximately 45° bypass then back down to ‘level’... - Page 7 ST10+ AND CGO2+ BINDING Step 1) Turn on the ST10+, and if required tap the screen (outside of the Step 5) if required tap the pop up status window) to bypass the RC and WiFi connection process. screen (outside of the pop status window) bypass the RC and WiFi...
-
Page 8: Certification Information
CERTIFICATION INFORMATION FCC STATEMENT: turning the equipment off and on, the user is encouraged to try to correct This equipment has been tested and found to comply with the limits for the interference by one or more of the following measures: Part 15 of the FCC rules.
Need help?
Do you have a question about the ST10+ and is the answer not in the manual?
Questions and answers
bottom row icons (system setting, flight setting, flight mode) isn't recognized when tapped. Also, home and return icons don't do anything.
@Gary Lawler I have Not updated firmware. ST-10 Yuneec Blade
If the bottom row icons on the YUNEEC ST10+ remote are not responding when tapped, try the following steps:
1. Ensure the camera is connected and active, as some settings may not be accessible otherwise.
2. Check if the system is fully powered and updated.
3. Restart the remote controller to reset the interface.
4. Confirm that the touchscreen is functioning properly and is not frozen.
If the issue persists after these steps, further troubleshooting or technical support may be needed.
This answer is automatically generated