Summary of Contents for Mannol HC-2197
- Page 1 Pneumatic Oil Extractor Operation Manual Model No. : HC-2197 To prevent serious injury, Read and understand all Warnings and instructions before use. Operators must obey all safety procedures & instructions...
-
Page 2: Table Of Contents
INDEX Specifications ........................3 Save this manual ......................3 General safety rules ......................3 Safety Warnings and Precautions ................... 3 Specific safety rules for this product ................4 Warning .......................... 5 Transport and unpacking ....................5 Features ........................... 6 Assembly instructions ..................... 6 Operation instructions ..................... -
Page 3: Specifications
Specifications Function collect waste oil from vehicle gear box or engine Power Compressed air Air Consumption About 200L/min Air Inlet Pressure 87~116PSI/6~8Bar Oil ejection pressure 10~14PSI/0.7~1Bar Vacuum Degree 0 ~ -14PSI/0~-1Bar Tank Capacity Perspex cylinder Capacity(Practicable/total) 9/10L Collect tray capacity Height About 1350mm~1750mm ℃... -
Page 4: Specific Safety Rules For This Product
2. Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically powered tools in the presence of flammable gases or liquids. 3. -
Page 5: Warning
6. Always protect your skin and eyes from contact with oil and solvents. 7. Do not start engine during the time of oil extraction. Otherwise it will cause the damage of extraction probes and injuries of people. 8. Be careful for the oil extracted out from the vehicle, as temperature of oil is high, always between 40~60℃. 9. -
Page 6: Features
there are no parts which have been visibly damaged. If any parts are missing or broken, please contact with local distributor as soon as possible. Remove the contents of the packages and place them in a storage area inaccessible to children or animals. -
Page 7: Operation Instructions
FIG.3 2. Pull out the lift pole and install the oil tray on the lift pole. 3. Install and fix the oil tray, strain, extension funnel together. 4. Ensure the lift pole is perpendicular to the equipment. 5. Please lift up the oil tray above cylinder with 1cm height during installation of cylinder. Fix the lifting pole to position to avoid rubbing against each other. - Page 8 4. Then oil transferring from oil tray to oil tank. 5. Screw on the drain plug of vehicle. Vacuum Generation Operating air pressure: 87~116PSI /6~8 bar Consumption of air: 52 Gallons/min (about 200L/min.) If only measuring glass to be vacuum(FIG.9) ○...
- Page 9 engine. ○ 3. Turn on the ball valve ○ 4. If waste oil only extracted into the cylinder. Please make sure the ball valve 3 is closed. ○ 5. If waste oil extracted to the oil tank through the cylinder. Please open the ball valve 3 accordingly.
- Page 10 Tips It will be faster for transferring of waste oil from transparent measuring glass into oil tank, if vacuum generated in both transparent measuring glass and oil tank. Tank Emptying When the oil retained in tank near full(see oil window), You need to eject oil out into a disposal tank and resolve the waste oil accordingly to the instruction of local government.
-
Page 11: Trouble Shooting
in the tank. Otherwise, oil will spray out. Safety Device 1. A safety valve on the top of the tank will release pressure when pressure is over 14PSI/1bar during ejection. 2. A safety device was fixed on the top of the cylinder which could avoid the cylinder exploding while the compressed air enter the cylinder. - Page 12 FIG.9...
-
Page 13: Exploded Drawing
Exploded drawing...
Need help?
Do you have a question about the HC-2197 and is the answer not in the manual?
Questions and answers