Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Spondoolies SPX36
- Page 1 SPX36 Quick Start Guide Oct 2018 Document Revision 03...
- Page 2 NOTICE The information in this document is deemed to be correct at the time of publishing. Spondoolies reserves the right to change specifications without notice. Spondoolies is not responsible for incidental, consequential, or special damages of any kind in connection with using this document.
-
Page 3: Table Of Contents
Overview ................................... 4 Description ..............................4 3.1.1 Front Panel ........................... 4 Specifications ..............................5 Installing your SPX36 ..............................5 Prerequisites ..............................5 Installation Procedure ..........................5 Shutting Down .............................. 5 Configuring your SPx36 ............................6 First time login to the Management Console ....................6 Setting the pool information ........................ -
Page 4: Introduction
Overview This SPX36 Quick Start Guide gets you going and allows you to start mining. Carefully read the instructions to ensure that you install the SPX36 properly and in an appropriate and safe location. -
Page 5: Specifications
Ethernet port on the SPX36 front panel. Connect the two AC power cords supplied with the SPX36 to the PSUs on the front panel, then connect the other end with the C-14 plug to a suitable power outlet (30A rating per unit). -
Page 6: Configuring Your Spx36
If you know the IP address, for example by looking on you ethernet router/switch GUI or by other means, you can skip this process. On a computer connected to the same local network as your SPx36, run IP scan tool. NOTE ... -
Page 7: Setting The Pool Information
SPX36 Quick Start Guide Configuring your SPx36 Setting the pool information To configure pools: Using a browser, browse to the IP address of the unit. Enter username & password: admin admin On the website Main Menu, click Pools. In the URL field, enter the pool URL and port number separated by a colon. - Page 8 Configuring your SPx36 Click Submit. The SPx36 restarts. After reloading has finished, the pool you added appears in the list of pools on the main screen and you can follow its status: 10. To add another pool, repeat steps 3 - 9 .
-
Page 9: Firmware Upgrade
SPX36 Quick Start Guide Configuring your SPx36 Firmware upgrade To configure pools: On the website Main Menu, click Firmware Upgrade. Press the Upload FW file to pick the new firmware Upload the new image using the chose file button After picking the image file, click upgrade from file.
Need help?
Do you have a question about the SPX36 and is the answer not in the manual?
Questions and answers