DCS CMOSTK27 Use & Care Manual

MODELS CMOSTK27 AND CMOSTK30
CONVECTION MICROWAVE TRIM KIT
PARTS INCLUDED:
Part Name
Trim Assembly
Base
Rear Duct
Forward Duct
Tape Foam
BEFORE INSTALLING TRIM KIT, INSTALL THE CONVECTION DUCT
1. Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied.
2. Install foam tape on 2 edges of the rear section of the duct.
3. Remove and retain the 2 top screws located at the rear vertical edges of the Microwave.
4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3.
INSTALLING TRIM KIT
1. Cut opening in the cabinet face per the following dimensions:
A Height: 19-3/16" + 1/16" , –0
B Width: 25-3/4" + 1/16" , –0
Refer to diagram on the following page. The minimum cabinet depth is 20" . When installing the
Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the
recommendations in the Microwave Installation/Use & Care Manual.
2. Add adequate support in the bottom of the cabinet for trim kit base to rest on.
3. Mark a centerline on the front edge of the cabinet bottom.
4. Place trim kit base and align centerline mark to the triangular notch on the front edge of the base.
5. Drill 1/8" pilot holes and install screws through the base into the cabinet to prevent the base from
shifting.
6. Insert Microwave into opening on top of the base. The Microwave feet should sit in recesses on the
base for correct alignment.
Quantity
1
1
1
1
2
Part Name
Strike & Catch Male
Strike & Catch Female
Mounting Bracket (L/R)
Sheet Metal Screws
(refer to diagram on following page):
Quantity
4
4
2
14