Advertisement
7. Install the mounting bracket supports by resting the bottom
edges of the supports on the bottom of the cutout. The long
flange on the side supports should clear the side of the
cutout by approx. 1/16" . (see Fig 01.) Install top screws into
the cabinet face by first drilling 1/8" pilot holes.
(See Inserts 3 and 4.)
8. Install trim kit face by inserting top pins of trim into corre-
sponding sockets on the top corners of clip support plates
(See Insert 1 ).
9. Finish the assembly by inserting the bottom pins into the corre-
sponding sockets on front edge of the base (See Insert 3).
FORWARD
CONVECTION
DUCT
SCREW HOLE
MOUNTING
BRACKET
SUPPORT
TRIM KIT
ASSEMBLY
INSERT 4
BOTTOM PIN OF TRIM
INSERT 3
REAR
CONVECTION
CABINET
DUCT
FOAM TAPE ON
THIS FLANGE
LOCATE MOUNTING BRACKET
IN BOTTOM CORNERS
OF CUTOUT
SCREW HOLE
5800 Skylab Road, Huntington Beach, CA 92647
Tel: 714.372.7000 • Fax: 714.372.7001
Customer Service: 888.281.5698
www.dcsappliances.com
FOAM TAPE ON
THIS FLANGE
B
1/8" HOLE FOR
MOUNTING
SCREW
CENTER
LINE
CENTERING
NOTCH
FLANGE
HORIZONTAL
CLIP ORIENTATION
ON BASE
1/16"
Fig. 01
VERTICAL
CLIP
ORIENTATION
ON MOUNTING
BKT.
TOP PIN
OF TRIM
INSERT 1
BASE
A
INSERT 2
P/N 11394-01 Rev. A 03/04
Advertisement
