Breaking In The Compressor; Air Connection Setup - McGraw 64857 Owner's Manual

Breaking in the compressor

1� Turn the Power Switch OFF and unplug Power Cord�
2� Fully open Drain Valve�
3� Plug in the Power Cord�
4� Turn the Power Switch ON�

air connection Setup

1� Connect a regulator valve, an inline shut off valve
and a 1/4" NPT air hose to the Quick Coupler
(all sold separately)� The air hose must be long
enough to reach the work area with enough extra
length to allow free movement while working�
note: an in-line shutoff ball valve is an important
safety device because it controls the air supply even
if the air hose is ruptured. the shutoff valve should
be a ball valve because it can be closed quickly.
Item 64857 For technical questions, please call 1-888-866-5797.
5� Let the unit run for 30 minutes�
Air will expel freely through the Drain Valve�
6� Turn the Power Switch OFF�
7� Unplug the Power Cord and close Drain Valve�
2� Depending on the tool that will be used
with this compressor, incorporate additional
components, such as an in-line oiler, a filter,
or a dryer (all sold separately), as shown on
Figure A on page 10 and Figure B on page 11�
Consult air tool's manual for needed accessories�
Page 9