Advertisement
Quick Links
Advertisement
Summary of Contents for MAKSIWA CPD/3.C
- Page 1 OPERATING INSTRUCTIONS DUST EXTRACTOR CPD/3.C 0909...
-
Page 2: Table Of Contents
CONTENTS TECHNICAL DATA……………………………………………………………….1 UNPACKING AND CHECKING CONTENTS………………………………….2 ASSEMBLY………………………………………………………………………..2 SAFETY RULES………………………………………………………………….5 WIRING DIAGRAM……………………………………………………………..6 PARTS DIAGRAM……………...…………………………………………….…..8 PARTS LIST…………………………………………………………………….…9 PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn... -
Page 3: Technical Data
TECHNICAL DATA Motor power (Watt) 2200 Inlet diameter (mm) 1-150/3-100 Fan diameter (mm) Bag capacity (cubic meter) 0.43 Overall size (LWH)(MM) 1460x720x1860 Weight (kgs) PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn... -
Page 4: Unpacking And Checking Contents
READ THIS MANUAL CAREFULLY BEFORE ASSEMBLY, TESING AND OPERATING. WARNING: DO NOT OPERATE THIS UNIT UNTIL THE PVC HOSE IS INSTALLED ONTO THE DUST INLET PORT. UNPACKING AND CHECKING CONTENTS Unpack carton, check machine, to see parts listed below: A. CONNECTOR B. - Page 5 Fig 1 With the motor base, collector body & fan/motor assembly in place, secure it to the base plate using the screw and washers provided as shown in Fig 2. Fig 2 Install the packing and square connecting tube, connector to the collector body assembly using screw and washers provided.
- Page 6 Fig 4 Next install the two collectors (C) two packing (I) to the outlet as shown in Fig5. Fig5 Install the two collector supports (F)and two upper bag support (E) as shown in Fig 6. Fig 6 Next, hang the two bags (H) from the support rods. Then attach the two filter bags and two collection bags to the collectors using bag clamp.
-
Page 7: Safety Rules
The inlet can now be placed on the intake hole of the fan/motor assembly as shown Fig 7. Fig 7 The dust collector is now ready to be placed into service. Before connecting to a power source, be sure the power source is properly grounded and is of proper voltage and amperage. -
Page 8: Wiring Diagram
which it was designed. 12. Use correct tool. Do not force machine or attachment to do a job for which it was not designed. 13. Wear proper apparel. Do not wear loose clothing, neck ties, gloves, jewelry, etc. 14. Remove adjusting keys and wrenches. Before turning the machine on, make it a habit to check that all adjusting keys and wrenches have been removed. - Page 9 WIRE DIAGRAM:(SINGEL PHASE) WIRE DIAGRAM:(THREE PHASE)
-
Page 10: Parts Diagram
PARTS DIAGRAM PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn... -
Page 11: Parts List
PARTS LIST Part No. Description Part No. Description CASTER COLLECTOR SUPPORT SCREW RIGHT-COLLECTOR SCREW WASHER BASE PLATE UPPER BAG SUPPORT SCREW FILTER BAG INLET PACKING SCREW INLET WASHER SWITCH TURBO FAN WRENCH HEX COLLECTOR CABLE WASHER MOTOR BASE BAG CLAMP SCREW HEX SWITCH BOX SCREW HEX...