Page 5
Assembly Step one Attach the front (18) and rear feet (14) to the frame using the nuts (8), washer (9) and bolts (10). Step two Attach the handlebar post (22) by inserting it into the head tube of the frame. Use the release lever to adjust and tighten the height to the desired position.
Part list Name Unit No. Name Unit Saddle BB bearing Alloy bind clamp ( L ) BB Axle with plate Spring for release lever Flywheel axle Alloy bind clamp ( R ) Fixed wheel nut Washer for release lever Flywheel bearing Release lever Flywheel security nut (7t) Crank bolt...
Name Unit No. Name Unit Bolt for protection tube Fixed bolt for plate Rubber cover for flywheel Washer for protection tube Adjuster cable guide Bottom tube cover w/adhesive tape Sensor cable Flywheel protection tube Magnetic holder w/magnetic set SET Instruction Use 1) The bike is designed to be used as a “spin “...
Maintenance Chart DESCRIPTION Daily Weekly Monthly Quarterly Annually Keep machine clean: Wipe machine down with clean & dry fabric to clear dirt & sweat. Wipe Anti-rusty cream or similar on the seat post set, handlebar set Visual check Check security of handle bar post &...
ELECTRONIC CONSOLE OPERATION CONSOLE SPECIFICATIONS : Cadence bar graph : 0-200RPM, 10RPM per bar. RPM measure : 0-240RPM Speed : 0-96 KM/H (0-60MPH) Pulse : Analog signal, 30-240 BPM Watt : 0-999 Watt Time : Countdown range : 1-99 minutes Count up range : 00:01 –...
Page 11
CONSOLE OPERTION QUICK START : The console will go to power saving mode when remaining idle for several minute. To start the console again, press any key. MODE SELECTION : Press the left-hand key to select the measurement to be shown on the bottom of the display ( Speed, distance, time or clock ).
Page 12
SET THE HEART RATE ALARM : To activate or deactivate the heart rate alarm, Press the right-hand key. When the alarm is ON, the alarm icon appear on the display and a “ beep” will sound to indicate that your heart rate is either above or below the target zone. SET THE WORKOUT TIME, HEART RATE LIMIT &...
Page 13
KM/H to MPH, press the left-hand key until the MPH or KM/H appears at the bottom of the screen, then use the right-hand key to switch from one unit to the other. When the values are properly set, wait about 8 seconds and the screen will return to the standard display.
Limited Warranty This product carries the following guarantee against manufacturing defects: * Frame is warranted for 2 years from the date of purchase. * Components are warranted for 1 year. * Warranty is only valid for the original purchaser. * Labor and freight charges are not included. * Normal wear, neglect, abuse, accidents, improper assembly or maintenance, or the installation of parts or accessories not compatible with the original intended use of the bike, as sold, are...
Need help?
Do you have a question about the RX125v3 and is the answer not in the manual?
Questions and answers