Setting The Time - HoMedics PDM-100A Instruction Manual

SETTING THE TIME

Note: To start, please install the battery. For
more information, refer to the INSTALLING
THE BATTERY section of this manual.
The pedometer will turn ON and will show
full LCD segments for 2 seconds and then
will automatically display the TIME. If the
pedometer does not automatically display
this mode, press the MODE button until
the time is displayed.
1. While in TIME mode, press and hold
down the SET button for 3 seconds.
The HOUR should be blinking.
2. To increase the HOUR, press the
RESET button. Each press will increase
the number by one in a cycling manner.
Pressing the MODE button will confirm
the entry.
3. Change the MINUTE, SECOND and 12
or 24 HOUR MODES as described in
step 2 above, using the RESET button
to increase the selection and the MODE
button to confirm the entries.
9