Advertisement
INSTALLATION INSTRUCTIONS
The Hyperion Ag luminaire is shipped as two seperate components, the Hyperion Ag
body and the diffuser.
Hyperion Ag | T-Bar
Step 1: Lift Hyperion Ag luminaire into ceiling cavity.
Step 2: Complete electrical connection.
Step 3: Position luminaire centrally within T-Bar.
Step 4: Remove plastic film from reflector.
Step 5: Ensure lamp is fitted correctly.
Step 6: Insert diffuser into luminaire.
Hyperion Ag | Plaster Recessed
The Plaster Recessed Hyperion Ag is also shipped with a Plaster Recessing
Acessory, which includes mounting brackets and fasteners.
Step 1: Cut-out the correct hole size in the ceiling for your Hyperion Ag luminaire.
Step 2: Lift plaster frame to plaster cut-out.
Step 3: Insert and fasten plaster recess brackets into slots as indicated in Diagram
A. Ensure fasteners are not overtightened.
Step 4: Remove lamp and reflector from luminaire.
Step 5: Lift Hyperion Ag into ceiling cavity.
Step 6: Complete electrical connection.
Step 7: Position luminaire centrally within plaster frame.
Step 8: Refit reflector into luminaire, remove plastic film and refit lamp.
Step 9: Insert diffuser into luminaire.
Hyperion Ag | Surface Mounted
Note:
Surface Mounted Hyperion Ag luminaires must be hard wired.
Step 1: Lift surface mounting body to ceiling, feeding the supply cable through the
cable entry hole.
Step 2: Secure the body onto the mounting surface with appropriate fasteners (not
supplied) to suit mounting substrate.
Step 3: Complete electrical connection.
Step 4: Slide the Hyperion luminaire into the surface mounted body and
connect the earth lanyard to the end.
Step 5: Slide the end into the surface mount body.
SURFACE MOUNT END
LUMINAIRE
HEAD OFFICE | MELBOURNE
SYDNEY
EAGLE LIGHTING VIC
EAGLE LIGHTING NSW
17-19 Jets Court
Unit 4, 21 Mars Road
Melbourne Airport VIC 3045
Lane Cove NSW 2066
P 03 9344 7444
P 02 9420 5799
F
F
03 9344 7433
02 9420 5988
Diagram A.
SURFACE MOUNT BODY
BRISBANE
CANBERRA
EAGLE LIGHTING QLD
EAGLE LIGHTING ACT
53 Caswell Street
M 0411 889 406
East Brisbane QLD 4169
P 07 3891 0744
F
07 3891 0755
HYPERION Ag
GENERAL INFORMATION
+ A qualified electrician, in accordance with
AS/NZS 3000:2007 wiring regulations
should carry out connection to mains
wiring.
+ This unit must be EARTHED.
+ Ensure that the rated voltage and
frequency requirements are compatible
with the available mains supply,
220-240V 50Hz
+ Cleaning of reflectors and lenses should
be carried out using clean, soft and lint
free cloths and anti-static cleaning fluid.
+ Do not carry out high voltage insulation
test i.e. 500/1000V this may damage the
fixtures electrical components.
EAGLE LIGHTING AUSTRALIA PTY LTD.
ABN 46 124 400 933
Advertisement
