Advertisement
RE920 IP Module
Features
• Connects in daughterboard slot of SimonXT panel
• Allows reporting of alarm and status conditions over IP connection
• Allows control of system functions (arming, disarming, etc) over IP
connection
• Allows control of Zwave devices and wireless siren over IP connection
Key Instructions
• Install RE920 unit in slot at back of panel
• Power up the panel
• Connect ethernet cable
• Connect to configuration software and enter MAC address
• Configure RE920 to correct IP address for reporting
• Configure RE920 to correct IP address for system control
LED Operation
• "L and S" LEDs are normal ethernet LEDs and indicate healthy ethernet
network connection
• "Power" LED lights green when powered and shows heartbeat for
processor functioning correctly
• "Local" LED lights when proper connection to local router established
• "CS" LED lights when connected to Central Station
• "Platform" LED lights when connected to interactive platform website
Page 1 of 4
RE920_IP_Module_Manual.doc
www.ResolutionProducts.com
07-Apr-12
Advertisement
Table of Contents
Summary of Contents for Resolution Products RE920
- Page 1 • Allows control of Zwave devices and wireless siren over IP connection Key Instructions • Install RE920 unit in slot at back of panel • Power up the panel • Connect ethernet cable • Connect to configuration software and enter MAC address •...
- Page 2 Specifications Panel Compatibility: GE/Interlogix SimonXT External supply: 9-18V DC, at least 100mA. Current draw: 60mA, normal operation. PCB dimensions: 1.9 x 4.1 inches Specifications subject to change without notice. Internal Picture Printed Zwave Antenna Factory Default Switch Ethernet LEDs Status LEDs Ethernet Connector Mounting Holes RE920_IP_Module_Manual.doc...
- Page 3 OEM Installation Instructions The RE920 module is installed in the SimonXT host as follows: 1. The SimonXT should be powered down. 2. Expose the back of the panel as shown in the following picture. 3. The module is installed in the expansion slot on the left, as shown in the picture.
- Page 4 Notices “GE” is a trademark owned by General Electric Company. "Interlogix" is a trademark of UTC. This Resolution product is not produced by, endorsed by, or officially associated with GE or UTC. Resolution recommends verifying operation at installation. This product is only usable with the GE/Interlogix SimonXT alarm panel. FCC Notice This device complies with Part 15 of the FCC rules.
Need help?
Do you have a question about the RE920 and is the answer not in the manual?
Questions and answers