Electric Fuel WAB-H12 Operating Instructions

Advertisement

This document is the sole property of Epsilor-Electric Fuel Ltd. (EEF) and contains information
proprietary to EEF. Any reproduction, disclosure or other use thereof is prohibited, except as otherwise
agreed to in writing by EEF. EEF reserves the right to demand return of this document at any time.
The conditions and test required for TSO approval of this article are minimum performance
standards. It is the responsibility of those desiring to install the article either on or within a
specific type or class of aircraft to determine that the aircraft installation conditions are within
the TSO standards, the article may be installed only if further evaluation by the applicant
documents an acceptable installation and is approved by the local aviation authority.
Confidential – Epsilor-Electric Fuel Proprietary Information
WAB-H12-Instruction-Manual.doc
E p s i l o r - E l e c t r i c F u e l L t d .
CONTENT
WAB-H12 Instruction Manual
Western Industrial Park, 1, HaSolela St.,
Bet Shemesh, 99054 Israel
Rev
D

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WAB-H12 and is the answer not in the manual?

Questions and answers

Summary of Contents for Electric Fuel WAB-H12

  • Page 1 Western Industrial Park, 1, HaSolela St., Bet Shemesh, 99054 Israel This document is the sole property of Epsilor-Electric Fuel Ltd. (EEF) and contains information proprietary to EEF. Any reproduction, disclosure or other use thereof is prohibited, except as otherwise agreed to in writing by EEF. EEF reserves the right to demand return of this document at any time.
  • Page 2 Description of Device The Survivor Locator Light WAB-H12 is a single-use product that consists of a water- activated battery and a light assembly, connected by an electrical wire. The battery consists of a cuprous chloride cathode flanked by magnesium alloy anodes in an injection-molded plastic case.
  • Page 3 Continue as 5.1.b. Other methods of mounting the WAB-H12 on life vests may be used by the life vest manufacturer but the method should be in such a way that it will not damage the battery.
  • Page 4 Lifevest or liferaft assembly should be packaged as soon as possible after battery is installed and not left open to the environment. Please note that even when packed in the life jacket bag the WAB-H12 should still be protected from high humidity (not above 60%).

Table of Contents