Summary of Contents for iTrainer iTrainer Mini
-
Page 2: What's In The Box
What’s in the Box The iTrainerMini package includes the following items. iTrainerMini Device Quick Start Guide iTrainerMini USB Data / Charge Cable... - Page 3 Your iTrainerMini Device 1. Power Switch 2. Status Indicator 3. USB/Power Connector 4. Visual Cue Indicators 5. Memory Card Socket...
- Page 4 Charging your iTrainerMini The micro-USB connector acts as both a charge connector and a data communication port for firmware updates and diagnostics. The supplied micro-USB-to-standard USB cable should be connected to a PC or USB charger. The device should be powered off prior to plugging in the charge cable to allow it to charge more quickly.
- Page 5 Turning the iTrainerMiniTM On/Off The power switch is located on the rear of the unit below the MicroUSb connector. Make sure the USB cable is disconnected, then press and hold the button for 0.5 seconds to power the unit on. The status indicator will cycle through various colours before settling to a blinking green, then white.
- Page 6 MPGT can be found on the following website: www.mypersonalgolftrainer.com iConsole iConsole is an application for Android and iOS powered phones and tablets that is specifically designed to work with the iTrainerMini iTrainer. You can download the entry level application from the Android market or iTunes store.
- Page 7 Setting up the iTrainerMini™ The iTrainerMini™ comes fully charged, but recommend you charge the device for at least 2 hours before first use. Before working with the iConsole™ software, turn on the iTrainerMini™ and configure the Bluetooth Settings under the settings page on the iConsole’s home screen.
- Page 8 Updating the iTrainerMini Firmware In the event the iTrainerMini™ requires a firmware update, you need to plug the device into the PC using the supplied USB cable and then power on the unit. Note: The power button, by design, is more difficult to press when the cable is plugged in.
- Page 9 Open the ‘C’ clamp on the bottom of the iTrainerMini™ Snap the iTrainerMini™ onto the shaft, just below the grip. Try to line it up so the iTrainer is perpendicular to the clubface. Note: It is ok for the clamp to touch the grip, but if it iinteferes with the hands, move it down slightly Rotate the locking ‘C’...
- Page 10 More Information Safety precautions • AVOID placing the iTrainerMini™ in direct sunlight. • AVOID high temperatures when operating the device • DO NOT submerge the iTrainerMini™ in water. • DO NOT drop the iTrainerMini™ onto a hard surface from a height of 6 feet or more •...
- Page 11 FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 12 - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the iTrainer Mini and is the answer not in the manual?
Questions and answers