Advertisement
CMM-9301-V3.1S
C-MAX
Bluetooth 4.0 Single Mode HCI Module
OEM END PRODUCT USER MANUAL STATEMENTS
The OEM integrator should not provide information to the end user regarding how to install or remove
this RF module or change RF related parameters in the user manual of the end product.
If this module is intended for use in a portable device, you are responsible for separate approval to
satisfy the SAR requirements of FCC Part 2.1093.
The user manual for the end product must include the following information in a prominent
location:
This device is granted for use in mobile only configurations in which the antennas used for this
transmitter must be installed to provide a separation distance of at least 20 centimeters from all
persons and not be co-located with any other transmitters except in accordance with FCC and Industry
Canada multi-transmitter product procedures.
The end product with an embedded FCC ID: 2ABBXCM9301V312013 Module may also need to pass
the FCC Part 15 unintentional emission testing requirements and be properly authorized per FCC Part
15.
The labeling instructions of finished products refer to following requirements:
A certified module has the option to use a permanently affixed label, or an electronic label (see
Electronic Labeling below). For a permanently affixed label, the module must be labeled with an FCC
ID - Section 2.926 (see Certification labeling requirements above). The OEM manual must provide
clear instructions explaining to the OEM the labeling requirements, options and OEM user manual
instructions that are required (see next paragraph).
For a host using a certified module with a standard fixed label, if (1) the module's FCC ID is not visible
when installed in the host, or (2) if the host is marketed so that end users do not have straight forward
commonly used methods for access to remove the module so that the FCC ID of the module is visible;
then an additional permanent label referring to the enclosed module: "Contains FCC ID:
2ABBXCM9301V312013" must be used. The host OEM user manual must also contain clear
instructions on how end users can find and/or access the module and the FCC ID.
Other user manual statements may apply.
SPEC No.
Revision
State
C-MAX printed
Version
Page
CMM-9301-V3.1S
3.4
2013-12-13
2013-12-13
English
8 of 9
BLE HCI module
Advertisement
