Soen TRANSIT User Manual page 3

Brief Green Flashing:TRANSIT is plugged and switched 'OFF' indicating thebattery is fully charged.
Brief Purple Flashing: TRANSIT is plugged and switched 'OFF' indicating the battery is charging.
CONNECTTO YOURBLUETOOTHDEVICE
Watch quick & easy setup videos for some of the most popular smartphones and tablets online at
www.SoenAudio.com
Scan the QR code for direct access to the setup videos online.
1. Switch TRANSIT'ON'.
TRANSIT comes partially charged and ready to use right out of the box. Just switch it 'ON'. If the light is RED or does
not come 'ON' plug TRANSIT in using the included USB cable and charger. No damage will occur to the speaker or
battery if used before a full charge.
2.Press‐and‐hold the Option button'∞' until TRANSITbegins emitting the Bluetooth pairing tone. The LED light on
the switch will begin flashing blue indicating TRANSIT is in Bluetooth pairing mode and available to connect with
your Bluetoothdevice. NOTE: while in Bluetooth pairing mode, TRANSIT will emit the Bluetooth pairing tone every
3 seconds.
3.On the phone or device you are connecting, access the Bluetooth settings, turn Bluetooth'ON', then 'Add' or
'Search' for devices. When "TRANSIT" appears in the device list, select it. If a passcode is required, enter "0000".
OnceTRANSIT™ connects, it will emit the 'Connected' tone and the blue flashing light will stop. Time to Rock!
For additional Bluetooth setup help, review the instruction manual that came with the device you are trying to
connect.
NOTE: This is a one‐time setup for each device you connect to TRANSIT. To pair TRANSIT with another device,
st
repeat the steps above. TRANSIT will remember up to 8 devices. After pairing more than 8 devices, the 1 device
will have to be paired with TRANSIT again, in order to connect.
BluetoothAuto‐Reconnect
For your convenience, TRANSIT remembers the devices it pairs with, and will attempt to reconnect (for 15 seconds)
to the last connected device every time it is turned 'ON'. If your device is out of range orhas it's Bluetoothfeature
turned 'OFF', TRANSIT will not be able to reconnect automatically. If the device goes out of range or loses
connection with TRANSIT, you can easily reconnect by pressing the '∞' button once.
PLAY AUDIO USING THE 3.5MM CABLE
1. Connect the included 3.5mm stereo audio cable to any audio output device, and plug it into the TRANSIT
'3.5mm Audio Input' jack.
NOTE: When the 3.5mm jack is plugged in Bluetooth will be automatically turned off.