Table of Contents
Advertisement
a) Connect the armature of the leader motor to the BC145 input terminals "5"(-) and "7"(+).
b) Set the armature voltage of the leader motor to zero (0). Adjust the "MIN" trimpot so
that the output at terminals "9" and "10" reads zero (0) volts.
c) Reset the armature voltage of the leader motor to 90V. Adjust the "MAX" trimpot so
that the output voltage is 9V DC.
Notes:
1. When setting the output voltage using the "MIN" and "MAX" trimpots the voltage or speed
of the driven motor can be read directly instead of using the output of the BC145.
2. When readjusting the "MIN" and "MAX" trimpots, always set the minimum voltage first and
then the maximum voltage.
3. Trimpots allow approximately 20 turns for the full range of adjustment. If during the adjust-
ment procedure the output stops changing, try reversing the direction of rotation of trimpot.
IV.
OUTPUT SIGNAL
The output signal from the BC145 is obtained from terminals "9" (-) and "10" (+). Connect the
output directly to the signal following input terminal of the speed control. For multiple follower
motors, several controls can be driven from a single BC145. Be sure the AC line connections
to the follower control are to the same phase (eg, L1 to L1 and L2 to L2 of all controls.)
The output from the BC145 can be scaled to control the speed control over any desired speed
range. Adjust the "MIN" trimpot to provide the desired minimum speed and the "MAX" trimpot
to provide the desired maximum speed.
8
Advertisement
Table of Contents
