Battery Removal & Installation - Stealth Cam FX SERIES Instruction Manual

BATTERY REMOVAL & INSTALLATION
To remove the batteries; open the battery door to access and remove the batteries.
New, Alkaline or Lithium, 'AA' batteries must be inserted with the orientation as shown in
the compartment. As with most electronic devices the negative ( - ) orientation of the
batteries should be against the springs. Failure to insert the batteries properly will cause
damage to the unit.
Once batteries are properly installed and with the orientation correct, simply close the
battery compartment door back into its final locked position. Should the battery
door not willingly latch into it destination, remove the batteries and examine the area
of possible debris that may be causing the issue.
NOTE: Replacing the batteries will not reset the cameras current configurations.
**WARNING**
Do not mix new and old batteries.
Remove batteries from the tray if the unit will not be in use for extended period of time.
14
www.stealthcam.com Page
877-­‐269-­‐8490