Advertisement
Quick Links
XDS560v2 System Trace JTAG Emulator for CCS 4.x
XDS560v2
System Trace
Driver DVD
MIPI60 – 14TI
System Requirements
•
Microsoft Windows™ 2000/XP/Vista
•
2 GB of free hard disk space
•
Minimum 1 GB RAM, 2 BG recommended
•
Minimum 1.5 GHz, dual core recommended
•
Color display
•
Internet Access
•
USB port
•
Ethernet port
•
DVD reader
Service and Support
Web
http://support.spectrumdigital.com
E-Mail
support@spectrumdigital.com
12502 Exchange Dr., Ste 440, Stafford, TX. 77477
Quick Start Installation Guide
Kit Contents
+5V Universal
Power Supply
USB Cable
MIPI60 – 20CTI
The driver install supports the Spectrum Digital XDS560v2
System Trace JTAG Emulator in a CCS 4.2 or higher
environment. Emulation drivers are updated on a regular basis
so check the Spectrum Digital web site at
support.spectrumdigital.com. The XDS560v2 System Trace
JTAG Emulator will be referred to as the XDS560v2 STM.
Installation Overview
Installing the XDS560v2 STM is 3 step process:
1.
2.
3.
512106-4001B
T:281.494.4505, F:281.494.5310
MIPI60 – 20ARM
Installing the Code Composer Studio software
Configuring the emulator tail with correct target
adapter.
Installing the USB or Ethernet connection to the
host PC.
AC Power
Cords
Ethernet Cable
MIPI60 – 60TI
Page 1 of 4
www.spectrumdigital.com
Advertisement
Summary of Contents for Spectrum XDS560v2
- Page 1 Spectrum Digital web site at • support.spectrumdigital.com. The XDS560v2 System Trace Minimum 1 GB RAM, 2 BG recommended JTAG Emulator will be referred to as the XDS560v2 STM. • Minimum 1.5 GHz, dual core recommended • Color display Installation Overview •...
- Page 2 Apply power to the XDS560v2 STM by connecting the The figure below shows how the XDS560v2 STM power supply to the +5 volt input on the XDS560v2 emulator header plugs onto the target’s JTAG header. STM located on the rear of the emulator.
- Page 3 MAC Address found to the MAC address of your XDS560v2. The XDS560v2 MAC address is on printed on the back of your XDS560v2. CCSv4 takes the IP Address in the form of x.x.x.x for example 10.0.3.54. For USB the default “Emulator I/O Port Number” of 0 Align the emulator tail over the target connector, then push down should be used when connecting to a single XDS560v2.
- Page 4 512106-4001B Page 4 of 4 12502 Exchange Dr., Ste 440, Stafford, TX. 77477 T:281.494.4505, F:281.494.5310 www.spectrumdigital.com...
Need help?
Do you have a question about the XDS560v2 and is the answer not in the manual?
Questions and answers