Do you have a question about the 3000 and is the answer not in the manual?
Questions and answers
Summary of Contents for Reliance 3000
Page 1
INSTALLATION AND OPERATING INSTRUCTIONS OWNERS MANUAL MODEL 3000 CHAIR...
Page 2
QUALITY MANAGEMENT SYSTEM REGISTERED TO ISO 9001 ISO 13485 M A D E I N AM E R I C A Reliance® Medical Products Inc. • 3535 Kings Mills Road • Mason, Ohio 45040-2303 • 1-800-735-0357 • www.reliance-medical.com...
3.6. Chair Back Cover Removal (for servicing unit)...9 3.7. Gas Spring Adjustment........9 3.8. Replacement of Chair Back Cover......10 3.9. Removal of Lift (for servicing unit)....10 TROUBLESHOOTING GUIDE..........11 CLEANING AND MAINTENANCE ........12 PARTS LIST..............13 Model 3000 Chair Assembly........14 Chair Top Assembly..........16 Chair Base Assembly..........18...
à la présence d’importantes instructions de fonctionnement et de maintenance (service) dans ce manuel d’installation et d’instructions de fonctionnement. “NOTE” Amplifies a procedure, practice, or condition. “NOTE” Amplifie une procédure, pratique ou condition. Safe Working Load “Attention, Consult Accompanying Documents” Burn Hazard/Hot Surface IN-3000...
1.1. This manual contains information applicable only “NOTE” - la note indique des remarques to the Reliance® Model 3000 Chair. d’information particulière ou supplémentaire. 1.2. Whenever you see the symbols shown below, heed their instructions! Always follow safe operating 1.3 Should your product not perform properly, or if...
WARNING- Chair capacity in the upright the Chair) to loosen. position 500 pounds. 2.2.1.4. When the Pivot Bracket has been installed, tighten AVERTISSANT- Présidez la capacité en the screw until it is snug. Replace the Back Cushion. position droite 227 kilogrammes IN-3000...
3.1.1.1. A pedal-operated hydraulic lift is used to raise and can exceed the safe static load rating of lower the Reliance® Model 3000 Chair. The Chair may be this Chair, and may result in insufficient raised by pumping the Foot Pedal until the desired height is stability.
3.5. Headrest 3.5.5. Operation-No. 18 Headrest 3.5.1. The No. 11 Headrest is the standard Headrest for the Model 3000 Chair. 3.5.5.1. The No. 18 headrest is designed so it can be operated with just one hand. To unlock, squeeze the clear plastic actuator into Lock Housing.
Chair Back (Figure 7 Items 42, 43). against the Gas Spring pivot block. Remove the release On both sides of the release lever, loosen the allen screw lever that was used for testing. about two turns using a 3/32” hexagon allen wrench. IN-3000...
3.9.3. Lift up on the Chair top while tapping the piston rod bolt lightly with a hammer to free the piston rod from the Chair top assembly. 3.9.4. Completely remove the bolt from the unit. 3.9.5. Lift the Chair off of the base. IN-3000...
3.7) Headrest wobbles 1) Mounting screw loose 1) Tighten mounting screw Too much drag on swivel 1) Swivel lock partially engaged 1) Push down on the foot pedal to release swivel lock IN-3000...
Exercise proper care in cleaning and notify personnel in area of danger. Wear rubber gloves during all cleaning activity. Use caution in cleaning around buttons, stitching and wooden or other decorative trim, since these solvents could seriously damage such areas. IN-3000...
Should your Exam Chair not perform properly, or if replacement parts are needed, contact the Reliance® Distributor, where you purchased this product or contact the Technical Service Department, Reliance® Medical Products, Inc., 3535 Kings Mills Road, Mason, Ohio 45040-2303, or call (800) 735-0358.
Base Assembly* (See Figure 8) 1555773 Upholstered Arm Assembly** Headrest Assemblies (See Figures 10 thru 12) 3101273 Upholstered Back Assembly** ** Please specify upholstery color when ordering. To order complete Upholstery Set use P/N. 2764373 Cushion Set - 3000 - FX IN-3000...
Page 19
Washer, 5/16 SAE 0722899 S.H.S.S., 1/4-20 x .38 KCP 1633499 B.H.C.S., - 8-32 X 3/8 0527799 Nut, Flex Loc - 5/16-24 Table Figure 8 CHAIR BASE ASSEMBLY To order complete Base Assembly use P/N. 2828592 Base Assembly - 3000 IN-3000...
S.H.C.S. 1/4-20 x 1.00 1454799 B.H.C.S. 1/4-28 x 1/2 - Socket Table Figure 12 # 10 HEADREST ASSEMBLY To order complete Headrest Assembly use P/N. 665200 #10 Headrest Assembly* *Please specify paint color when ordering. ** Please specify upholstery color when ordering. IN-3000...
LIMITED WARRANTY The Reliance® product must be used only for the purposes and in the manner described in the literature distributed with the product. The products are warranted against defective materials and workmanship for a period of one (1) year from date of installation. Products or parts thereof will be repaired or replaced as required at Reliance®...
Need help?
Do you have a question about the 3000 and is the answer not in the manual?
Questions and answers