Advertisement
Quick Links
TAHI SHOWER SYSTEM
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Suitable for mains pressure.
Min. 150kPa, Max. 500kPa
Operating Temperature:
Recommended maximum
49°C. Max. 60°C
Inlet Connections:
All 1/2"
All pipework must be
thoroughly flushed prior to
installation of the system.
Advertisement
Summary of Contents for TAHI METHVEN
- Page 1 TAHI SHOWER SYSTEM INSTALLATION GUIDE TECHNICAL SPECIFICATIONS Operating Pressure: Suitable for mains pressure. Min. 150kPa, Max. 500kPa Operating Temperature: Recommended maximum 49°C. Max. 60°C Inlet Connections: All 1/2" All pipework must be thoroughly flushed prior to installation of the system.
-
Page 2: Exploded Diagram
exploded diagram Drencher outlet Drencher arm cover adaptor Drencher outlet seal Separate drencher cover Separate drencher spacer Attached drencher cover (Discard if installing Drencher assembly stand-alone drench shower) Rail top bracket cover Rail top bracket Rail top 45° cover Handpiece Hose elbow Rail Hose... - Page 3 pre Wall lining requiremenTS Fastening Zone -load bearing support required go to 12 on page 6 Hole Ø25mm Short Rail (13-8302) Seal holes. drive in screws (and Fastening Zone ensure edge is plumb, mark plumb Set bracket aside, drill clearance wall plugs where appropriate).
- Page 4 Fit foam seal around nipple. insert waterway into outlet and screw nut Slip top rail bracket under ensure edge is plumb, mark plumb Swing aside. drill clearance into Seal holes and drive in screws (and Tighten using a lever until bracket on to outlet loosely drencher bracket line to floor and mark screw holes...
- Page 5 go to 19 on page 8 Clip on cover No footrest ensure edge aligns with plumb line. push rail and bracket back on to Seal holes. drive in screws (and run water to ensure the unit is push rail and bottom rail bracket mark holes.
- Page 6 Cleaning Water contains lime which remains on the surface after To clean the chrome-plated surfaces use a soft cloth, the water has evaporated. These lime deposits can be soap and warm water. never use cleaning agents that prevented from forming by wiping immediately after use. contain a corrosive acid or a scouring additive.
- Page 7 For your warranty please refer to www.methven.com or call Customer Service New Zealand Australia 0800 804 222...
Need help?
Do you have a question about the METHVEN and is the answer not in the manual?
Questions and answers