Advertisement

OWNER'S MANUAL

Advertisement

Table of Contents
loading

Summary of Contents for LeMond WattBox

  • Page 1 OWNER’S MANUAL...
  • Page 2 WARNING Be sure to read all instructions and warnings included with your LeMond Revolution trainer before using this equipment. Failure to avoid the following potentially hazardous situations could result in death or serious injury. The Watt Box is designed for indoor use only.
  • Page 3 AVERTISSEMENT Veuillez bien lire toutes les instructions et les avertissements inclus avec votre LeMond Revolution trainer avant d'utiliser cet équipement. S'exposer aux situations potentiellement dangereuses suivantes peut entraîner la mort ou des blessures graves. Le Watt Box est conçu pour une utilisation en intérieur uniquement.
  • Page 4: Tools Required

    TOOLS REQUIRED 3mm Hex Key Small Phillips-Head Screwdriver ITEMS INCLUDED Watt Box R6 batteries - AA 3mm Hex-Head Screw...
  • Page 5: Installation

    INSTALLATION Place cover on top and fasten with the original screws There are two tabs located on the non-drive side of the Revolution’s main body. With the (2) 3mm hex key screws supplied, attach the Watt Box to the Revolution. (see below) Tabs Use a small Philips-Head screwdriver to remove the (2) screws on the back of the...
  • Page 6 PAIRING WITH COMPUTER Before you can pair the Watt Box must be properly installed on the LeMond Revolution trainer (Pg. 4). It is important to stay at least 10 meters away from other power-meters during this procedure. Navigate to the ANT+ pairing screen on your cyclometer and select Search (Figure 3.1)
  • Page 7: Turning Off/On

    With it paired, the Watt Box will display “0 Watts” when coasting. SUPPORT For Customer Support and Technical Questions, please contact: LeMond Revolution LLC 404 3rd Avenue North, Suite 203 Minneapolis, MN 55401 612-486-5750...
  • Page 8: Ce Declaration Of Conformity

    FCC CLASSIFICATION This device has been tested and found to comply with Part 15 of the FCC interference limits for Class B devices. Operation is subject to the following two (2) conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received including interference that may cause undesired operation.
  • Page 9 Industry Canada Compliance This device complies with Industry Canada license-exempt RSS-210. Operation is subject to the following two (2) conditions: 1) This device may not cause harmful interference and 2)device must accept any interference received including interference that may cause undesired operation.
  • Page 10: Warranty

    WARRANTY This is to certify that the LeMond® Watt Box™ is warranted by LeMond Inc. to be free of all defects in materials and workmanship. This warranty does not apply to any defect caused by negligence, misuse, accident, alteration, improper maintenance, or an “act of God.” The LeMond Watt Box Warranty assumes that the recommended service guidelines have been followed by the customer, and covers the following: One (1) Year warranty for the original purchaser.

Table of Contents