Summary of Contents for OptiPlus FWextender FWA100 Series
- Page 1 FWextender FWA100 Series FWextender™ IEEE1394 Optical Interface Adapter FWA100 Series IEEE1394 Fiber Optic Repeater USER’S Manual P/N : OPI –D04004RA Jan 2, 2004 Picture of FWA100 Series Model OptiPlus,Inc. 2 / 15...
- Page 2 FCC NOTICE THIS DEVICE COMPLIES WITH PART 15 OF THE FCC FULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITION: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED OPERATION.
-
Page 3: Table Of Contents
Touching the powered transmitter and powered receiver at the same time may result in electrical sock. Do not touch the module with wet hands Touching the housing and plug with wet hands is dangerous and can cause electrical shock. OptiPlus,Inc. 3 / 15 OptiPlus,Inc. 4 / 15... - Page 4 OptiPlus or its authorized agents, causes other then from ordinary use or failure to properly use the product in the application for which sad product is intended OptiPlus,Inc.
-
Page 5: Chapter 1 Introduction
The manual will be updated periodically to include latest component amplifiers or repeaters. revisions and respective specification changes. Please contact OptiPlus to obtain information on how to support all of OPI’s optical display interface. The IEEE1394 devices at each end in general interface to the FWextender by... -
Page 6: Chapter 2: Fwexteder Connector Descriptions
LC type port. Cable length is max 500m when use 50.0µm/120MMF multi mode glass fiber. Laser Class is 1 Eye Safety compliant ( 850nm VCSEL). 2.2 Optical Connector Definition Summary Tx Rx Figure 2.2 Optical LC Connector Define OptiPlus,Inc. 9 / 15 OptiPlus,Inc. 10 / 15... -
Page 7: Chapter 3 Functional And Interfacing Descriptions
The FWextender conversion box contains printed circuit boards mounted The FWextender cable incorporates in-line boxes to convert electric-to- with electronic components and OptiPlus electric-to-optic and optic-to-electric optical and optical-to-electric signals. The boxes contain electronic components modules. The physical dimensions are shown in the diagram below and depict the and circuitry that may be damaged if the cable is incorrectly plugged into either a expected final dimensions for the conversion box. -
Page 8: Electrical Characteristics
Optical Optical EOLink EOLink from 20m to 1Km in 10 m increments. from 20m to 1Km in 10 m increments. OptiPlus,Inc. 13 / 15 OptiPlus,Inc. 14 / 15... -
Page 9: Trouble Shooting
Check the LC optical cable connector Support Address : #1112 Sunil Technopia B’d 440 Sangdaewon dong, Jungwon gu, Seongnam city, Gyeonggi do, KOREA 462 – 120 TEL : 82-31-777-3570, FAX : 82-31-777-3573 Home Page : www.optiplus.co.kr Support : support@optiplus.co.kr OptiPlus,Inc. 15 / 15...