Advertisement
6 pcs - H3 Phillips Round Head Screw
2 pcs - H4 Phillips Round Head Screw
STEP 3:
First, feed the sensor plug from each P6 Goal Box with Sensors through each end apron and underneath table support
frames as shown in FIGURE 3 and UNDERNEATH TABLE DIAGRAM. Guide the sensor wires following the path shown
with the arrows in FIGURE 3 and THE UNDERNEATH TABLE DIAGRAM from the goal box pass through one side apron
and connect to P7 Electronic Scorer as shown in FIGURE 3.
Secure P6 Goal Box with Sensors onto P1 Air Hockey Cabinet using pilot holes with H3 Phillips Round Head Screws as
shown in FIGURE 3. Tighten, But do not strip out H3 Screws.
Secure P7 Electronic Scorer P1 Air Hockey Cabinet using pilot holes with H4 Phillips Round Head Screws as shown in
FIGURE 3. Tighten, But do not strip out H4 Screws.
Remove the battery cover from P7 Electronic Scorer and insert 2 AAA Batteries (not included) into the battery box.
Connect A4 AC/DC Adapter onto C1 DC Motor (underneath table) as shown.
P6
P7
H4
FIGURE 3
IMPORTANT NOTE:
Be sure to route the goal box sensor
wires thru the support beam cutouts
for correct assembly.
IMPORTANT NOTE:
As you attach the
P6
Goal Boxes,
make sure to very lightly pull any
excess wire thru the end apron that
may be blocking the electronic scoring
sensor eyes.
All Rights Reserved.
© 2016 Escalade Sports
PARTS REQUIRED:
2 pcs - P6 Goal Box with Sensors
1 pc - P7 Electronic Scorer
C1
DC Motor
(underneath table)
ELECTRONIC SCORER
C1
UNDERNEATH TABLE
6
C1
DC Motor
(underneath table)
P1
A4
P6
H3
IMPORTANT NOTE:
Be sure to route the goal box sensor
wires thru the support beam cutouts
for correct assembly.
DC Motor
For Customer Service Call 1-888-996-2729
Advertisement
