Page 1
Wireless Calling System Model : LM - 9000AT...
Page 2
1. System View Call Button LED Lamp Case Dip / Switch 2. Setting of Group ID [sw1] The Transmitter's Group ID must be the same as Receiver's Group [sw1] [sw2] [sw3] [sw1] No.1 No.2 No.3 No.4 No.5 No.6 No.7 No.9 No.10 No.11 No.12...
Page 3
[sw2, sw3] (No.01~99) 1) If push to Call SW, call number ID of transmitter will be transmitted to receiver. And the Receiver will be indicated call number ID. [sw1] [sw2] [sw3] 2) If clear indicated Call number in Receiver, push to Clear SW, call number ID of transmitter tens place units place will be clear the call number of Receiver.
** USER INFORMATION Acknowledging Special Precautions and the FCC Industry Canada Notice Cautions Modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC compliance Information When used the This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received.