Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Jing Si TZ-901
-
Page 1: Quick Start Guide
EXXXX Jing Si E-Book TZ-901 E-Reader Quick Start Guide... -
Page 2: Package Contents
• Do not put your TZ-901 E-Reader in an environment with direct sunlight or with a temperature above 50 C. Doing so may damage your TZ901 E-Reader. • Refer to the user manual saved in your TZ-901 E-Reader for more information. TZ-901 Quick Start Guide... -
Page 3: Top View
DRAFT v3 Getting to know your TZ901 E-Reader Top view Power button Front view Home button Touch screen Previous/Scroll panel up button Next/Scroll down button TZ-901 Quick Start Guide... -
Page 4: Bottom View
DRAFT v3 Bottom view Audio speakers Left view Right view Volume button microSD card slot Battery charge indicator micro USB .0 port Speaker/Headset port TZ-901 Quick Start Guide... - Page 5 To charge your TZ-901 E-Reader: Connect the micro USB cable to the power adapter. Plug the micro USB connector into your TZ-901 E-Reader. Plug the power adapter into a grounded power outlet. Charge your TZ-901 E-Reader for six (6) hours before using it in battery mode for the first time.
- Page 6 DRAFT v3 Turning your TZ-901 E-Reader on To turn your TZ-901 E-Reader on, press the power button for about three (3) seconds. NOTES: • To wake your TZ-901 E-Reader from standby mode, press the power button. • In the event that your TZ-901 E-Reader becomes...
- Page 7 DRAFT v3 Saving files in your TZ-901 E-Reader To save files from your compter to your TZ-901 E-Reader: Plug the micro USB connector into your TZ-901 E-Reader. Plug the micro USB cable to your computer’s USB port. On your TZ-901 E-Reader, tap Connect to PC.
- Page 8 DRAFT v3 Installing your TZ-901 E-Reader to the leather holster To install your TZ-901 E-Reader to the leather holster: Open the bundled leather holster. holder Place the TZ-901 E- Reader facing up then insert and slide it to the holder...
- Page 9 • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. TZ-901 Quick Start Guide...
- Page 10 Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT transmitting at the specified power level in different channels. TZ-901 Quick Start Guide...
- Page 11 SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: VRSTZ901. TZ-901 Quick Start Guide...
- Page 12 DRAFT v3 TZ-901 Quick Start Guide...