LFI Lights LED-SM11DL Series Installation Instructions

Components

LED Surface Mount Light

Important Safety Information

Please read these instructions carefully before attempting to install
this product. It is advisable to keep these instructions in a safe place
for further reference.
WARNING: All electrical connections must be in accordance with local and
National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper
electrical wiring connections obtain the services of a qualified electrician.
WARNING: RISK OF SHOCK electric current can cause painful
shock or serious injury unless
A. Turn off the power Supply at the fuse or circuit breaker box before you
install the fixture.
B. Ground the fixture to avoid potential electric shocks and to ensure
reliable starting.
C. Double-check all connections to be sure they are tight and correct.
D. Wear rubber soled shoes and work on a sturdy wooden ladder.
Maintenance & Care
1. Ensure that the power is disconnected prior to cleaning.
2. To keep the finish of this product, wipe over with soft cloth periodically.
3. Do not use harsh chemical solvents, it may dis-color or damage the finish.

Preparation for Installation

1. Read these instructions carefully before attempting to install this product.
2. Disconnect electrical power before installing or servicing any part of this fixture.
3. Place fixture on a clean flat surface.
Hardware Kit
WARNING: Risk of fire. Use only on 120 volt 60Hz circuits. Suitable for wet
locations. Before installing your lighting fixture, thoroughly review enclosed
installation manual.
Caution: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER
BEFORE INSTALLING THE FIXTURE, IN ORDER TO PREVENT POSSIBLE
SHOCK.
This fixture is designed for use in a circuit protected by a fuse or circuit breaker.
It is also designed to be installed in accordance with local electrical codes. If you
are unsure about your wiring, consult a qualified electrician or local electrical
inspector, and check your local electrical code.
WARNING: RISK OF CUTS Some metal parts in the fixture may have sharp
edges. To prevent cuts and scrapes, wear gloves when handling the parts.
CAUTION: FOR WET LOCATION INSTALLATION ON UNEVEN SURFACE,
ADD GASKET OR CAULKING COMPOUND ON BACK OF FIXTURE FOR SEAL
AGAINST MOUNTING SURFACE.
Made in China
INSTALLATION INSTRUCTIONS
LED Surface Mount Downlight
FOR LED-SM11DL ,LED-SM15DL SERIES
1 x Installation Instructions
Page 1