Block Diagram - Midas M32R Quick Start Manual

16 DIGITAL RACK MIXER M32R
5. Firmware Updates & USB Stick Recording
To Update Firmware:
1. Download the new console fi rmware from the
M32R product page onto the root level of a USB
memory stick.
2. Press and hold the RECORDER section's VIEW
button while switching the console on to enter
the update mode.
3. Plug the USB memory stick into the top panel
USB connector.
4. The M32R will wait for the USB drive to
become ready and then run a fully-automated
fi rmware update.
5. When a USB drive fails to get ready, updating
will not be possible and we recommend
switching the console off / on again for booting
the previous fi rmware.
6. The update process will take two to three
minutes longer than the regular boot sequence.
To Record to the USB Stick:
1. Insert the USB Stick into the port on the
RECORDER section and press the VIEW button.
2. Use the second page for confi guring
the recorder.
3. Press the fi fth rotary control under the screen to
begin recording.
4. Use the fi rst rotary control to stop. Wait for
the ACCESS light to turn off before removing
the stick.
Notes: Stick must be formatted for FAT fi le
system. Maximum record time is approximately
three hours for each fi le, with a fi le size limit of
2 GB. Recording is at 16-bit, 44.1 kHz or 48 kHz
depending on console sample rate.

6. Block Diagram

Quick Start Guide 17