Summary of Contents for PI Manufacturing ANT-S300CPE
Page 1
PI MANUFACTURING Powered by In nite Solutions 2.4GHz Wireless Outdoor CPE with ANT-S300CPE Installation Manual PI Manufacturing, www.pimfg.com...
Product Features Contents Overview Package Includes Hardware / Connection Web Interface 6-10 Typical Applications Master Mode Con guration 9-10 Slave Mode Con guration 9-10 Installation Notes 11-12 Speci cations PI Manufacturing, www.pimfg.com...
Overview The ANT-S300CPE is a 2.4GHz wireless outdoor CPE for long distance point-to-point wireless transmission up to 1km or 3281 feet. Supporting speeds up to 150Mbps, the wireless CPE uses an industrial Qualcomm chipset that delivers a more stable and e cient wireless communication.
Hardware and Connection Front Back Bottom Left Right PI Manufacturing, www.pimfg.com...
Page 5
Cover RJ45 Port RJ45 Port PI Manufacturing, www.pimfg.com...
Page 6
Cat5e / 6 cable from the LAN port on the power adapter to the computer or laptop. PoE LAN Can also connect to computer through LAN port on supplied Connect to PoE power adapter Connect to computer port on supplied power adapter PI Manufacturing, www.pimfg.com...
Page 7
Go into your preferred web browser, and type the following into the web address. http://192.168.248.1 The default username and password is “admin” (Once logged in, we recommend that you change the password to a more secure one. PI Manufacturing, www.pimfg.com...
The web interface is divided ino the following sections: - System Status - Quick Start - Network Tra c - Wireless - LAN IP - Administration - System Log For detailed options, view them on the web interface. PI Manufacturing, www.pimfg.com...
In a point-to-point setup, the master CPE is plugged into the internet while the slave CPE is connected to a computer, camera, or any other device. The maximum transmission distance is up to 1km (3281 feet). Slave Master Internet ANT-S300CPE PI Manufacturing, www.pimfg.com...
Page 10
The bridges in the same box are bridged by default when shipped from the factory. The following gure shows an example of the how to manually con gure the bridge. Slave Mode Master Mode Switch PI Manufacturing, www.pimfg.com...
Under bridge mode make sure Active Mode is toggled right to the gray color. The default Paired ID Number is set to 0. Make sure to click the apply button after making any changes for settings to take e ect. PI Manufacturing, www.pimfg.com...
Page 12
- The Master and Slave’s pairing ID must be the same for the connection to work. - The Master and Slave’s channel must be consistent. - The Master and Slave’s wireless passwords must be the same. - For testing the connection, ping each other’s bridge IP address. PI Manufacturing, www.pimfg.com PI Manufacturing, www.pimfg.com...
Do not use CCA cables. Avoid CCA cables. Only use bare copper cables • When installing the CPE, ensure that it is installed securely to avoid deviations caused by external factors, such as wind. Install securely to avoid movement PI Manufacturing, www.pimfg.com...
Page 14
Line of Sight Make sure the master and slave are at least 2 meters apart or else interference may occur. 2 meters apart PI Manufacturing, www.pimfg.com...
Vertical: 35°, Horizontal: 65° Gain 8dBi Web Management Encryption WPA2-PSK (AES) Operating Temperature -20°C~55°C Storage Temperature -40°C~70°C Operating Humidity 10%~90% RH non-condensation Storage Humidity 5%~90% RH non-condensation Support Power -40°C Dimensions 200 x 110 x 61mm Weight 2.35 lbs PI Manufacturing, www.pimfg.com...