Orbiloc Service Kit - ORBILOC Run Dual Safety Light Quick Manual

ORBILOC SERVICE KIT

The Orbiloc Service Kit makes maintaining
your Orbiloc Run Dual quick and easy.
The Orbiloc Service Kit contains a Lithium
Battery Pack (6) (2 x CR2032) and an O-ring
(3) lubricated with silicone.
CHANGE BATTERY & MAINTENANCE
Unscrew the Base (7) of the Orbiloc Run
Dual and replace the old O-ring (3) with a
new from the Orbiloc Service Kit. Replace
the old Battery Pack (6) with a new Battery
+
Pack (6) (with the
symbol facing down) in
the Base (7) of the Orbiloc Run Dual.
Make sure that the Mode Selector Ring (2)
is clicked firmly to the Lens (1). Please note
that the part with the small magnet has to
be placed in one of the four semi-circles on
the Lens (1), and that the Orbiloc Clip (5) is
placed in the designated guide pins on the
Lens (1). Screw the Lens (1) and Base (7) of
the Orbiloc Run Dual together again.
NOTE; Should the light be in and out of wa-
ter often, the O-ring (3) should be lubricated
with silicone and the light should be rinsed
after each time (please refer to page 6).
10