Anolis ArcSplitter 4 User Instructions

The ArcSplitter 4 divides LED input of ArcPower driver into 4 branches.This unit is designed for interior use
and should be connected to the ArcPower (ArcPower/K2) drivers only.

1. Fixture exterior view

 - Link cable
2 - LED outputs (to LEDs modules)
3 - LED input (from ArcPower driver)

2. Installation

1. Place the ArcSplitter 4 on a non-flammable flat surface in any orientation and fixed it with two screws.There
are two mounting holes of a diameter of 5 mm in a unit housing.
2. Connect the unit input (3) with LED output of the ArcPower driver.
3. Connect the LED modules to the unit´s outputs (2).
The max. load of each output depends on the number of used outputs:
Number of used outputs

2
3
4
Note: One LED output of the ArcPower drivers can be loaded 36 LEDs max.
Always connect outputs side by side, starting from output no.. Do not omit outputs. If you use less than 4
outputs, connect the link cable (1) with the first free output next to the last used .
4. Connect the ArcPover driver to the mains.
User instructions
ArcSplitter 4
Max. load per output
36 LEDs
8 LEDs
2 LEDs
9 LEDs