Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for Acoustas Melody-G
- Page 1 Melody-G Wireless Guitar Microphone Installation and Operation Manual...
- Page 2 Thank you for your purchase of an Acoustas Melody-G. Please visit our website at http://www.acoustas.com/ for up-to-date information on the Melody-G and other products and to contact us with questions or comments. This manual will describe how to properly install, connect, and operate your versatile new wireless microphone.
- Page 3 3300 W. Clay St., Richmond, VA, 23230 http://www.acoustas.com/ Federal Communications Commission and Industry Canada Notices for the Melody-G Master Unit (Transmitter) The master unit can be identified by these markings: Model/FCC ID: 2AC35-MELODYGTX IC: 12297A-MELODYG The following notices are applicable: This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s).
- Page 4 IC: 12297A-MELODYG The following notices are applicable: Note that the Melody-G slave transceiver may only be used with the 3 dBi gain monopole antenna provided, or a 50 Ohm antenna of the same type, with equal or lesser gain. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
- Page 5 Finally, re-string the guitar. A good first test of Melody-G is to connect the receiver to a computer's USB port in order to tune the guitar with the help of an online tuning application.
- Page 6 Transmitter and Receiver Pairing At any given time, each Melody-G receiver will only accept sound from a single transmitter. The transmitter and receiver form a pair and thus the method to link them is called “pairing.” Any receiver can be set to accept sound from any transmitter by pressing the pairing button and holding the two quite close together.
Need help?
Do you have a question about the Melody-G and is the answer not in the manual?
Questions and answers