Apollo STORM VINYL STORAGE Assembly Instructions

APOLLO STORM VINYL STORAGE ASSEMBLY INSTRUCTIONS

LIST OF COMPONENTS

A 4 X 8MM STEEL STUDS AND LOCKING NUTS
B 4 X LOCATING DISCS
C 4 X LOWER LEG CAPS
D 8MM STEEL SPIKES WITH LOCKING NUTS
E 1 X APOLLO BADGE
F 1 X OAK SHELF WITH (REMOVABLE) REAR OAK STOP BAR
G 2 X LEG RODS
H 4 X LEG BOLTS
I 4 X LOCATING DISCS
J 4 X LEG TUBES
k 1 X TOP OAK SHELF
L 4 X LOCATING DISCS

Lower module assembly

FIT LOCKING NUTS TO SPIKES (D), SCREW
SPIKES INTO THE LOWER LEG CAP (C) COPPER
THREAD .
TAKING THE STEEL STUDS (A) AND LOCKING
NUTS, FIT THE LOCKING NUTS APPROX.
10MM UP THE THREAD. SCREW THE STUD
INTO THE BACK OF THE LOWER LEG CAP
WITH THE LOCKING NUT FACING THE CAP.
TAKE ONE OF THE LOCATING DISCS MAKING
SURE THE INNER RAISED PART IS FACING
AWAY FROM THE LEG CAP AND SLIDE
DOWN THE STUD UNTIL IT LOCATES INTO
THE LEG CAP. REPEAT FOR ALL 4 LEGS.
TAKE THE LEG TUBES (J) AND FIT LACATING
DISCS (I, L) INTO BOTH ENDS OF EACH TUBE
WITH THE INNER RAISED PART FACING
AWAY FROM THE TUBE.
10MM
GAP