Power House Ice Eater - P750 Owner's Manual

Power House Ice Eater - P750 Owner's Manual

3/4 horsepower de-icer

Advertisement

Ice Eater - P750
3/4 Horsepower De-Icer
Owner's Manual
PLEASE READ ENTIRELY BEFORE OPERATING
10233 SOUTH DOLFIELD RD • OWINGS MILLS • MD • 21117 • PHONE 800-243-4741 • FAX 410-654-9706
INFO@THEPOWERHOUSEINC.COM • WWW.THEPOWERHOUSEINC.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ice Eater - P750 and is the answer not in the manual?

Questions and answers

Summary of Contents for Power House Ice Eater - P750

  • Page 1 Ice Eater - P750 3/4 Horsepower De-Icer Owner’s Manual PLEASE READ ENTIRELY BEFORE OPERATING 10233 SOUTH DOLFIELD RD • OWINGS MILLS • MD • 21117 • PHONE 800-243-4741 • FAX 410-654-9706 INFO@THEPOWERHOUSEINC.COM • WWW.THEPOWERHOUSEINC.COM...
  • Page 2 Notes 10233 SOUTH DOLFIELD RD • OWINGS MILLS • MD • 21117 • PHONE 800-243-4741 • FAX 410-654-9706 INFO@THEPOWERHOUSEINC.COM • WWW.THEPOWERHOUSEINC.COM...
  • Page 3: Table Of Contents

    Contents Safety Instructions page 2 Specifi cation Sheet page 3 Installation & Operation Instructions page 4 Maintenance & Trouble Shooting Tips page 5 Maintenance Log page 6 Parts & Accessories page 7 3-Year Limited Warranty page 8 Service & Repair Contact Form page 9 Warranty Registration &...
  • Page 4: Safety Instructions

    Ice Eater Safety Instructions WARNING WARNING WARNING CAUTION SHOULD BE USED WHEN DEALING WITH ANY ELECTRICAL EQUIPMENT WITH MOVING PARTS. WARNING WARNING WARNING NEVER LIFT OR DRAG THE UNIT BY THE POWER CORD. USE PROVIDED MOORING LINE TO MOVE THE UNIT AS NECESSARY. WARNING WARNING WARNING...
  • Page 5: Specifi Cation Sheet

    Ice Eater P750 Specifi cation Sheet INTRODUCTION When water freezes, it expands, becoming lighter. This fact is the principle upon which Ice Eater functions. Ice Eater’s propeller draws up warmer subsurface water and defl ects it to the surface creating a constant circulation of warmer water that prevents ice formation and melts existing ice.
  • Page 6: Installation & Operation Instructions

    Ice Eater Installion & Operation Instructions INSTALLATION Figure 1A Immediately after delivery, inspect the Ice Eater shipment for any visible damages. Report any damage to your dealer. The Ice Eater is completely assembled. You will not need additional hardware unless you are installing it with an optional dock mount or shallow water stand.
  • Page 7: Maintenance & Trouble Shooting Tips

    Ice Eater Maintenance & Trouble Shooting Tips MAINTENANCE TROUBLE SHOOTING TIPS • The Ice Eater motor is fi lled and sealed with a special 1) If unit does not start when plugged in or turned on: non-toxic dielectric lubricating fl uid and does not require a) Check power source to make sure that voltage is available.
  • Page 8: Maintenance Log

    Ice Eater Maintenance Log Date of Service (Replacement/Inspection) Standard Service Recommended every 4-5 years (includes replacement of bearings, seals capacitor, fl uid, & power cord connector Brackets Power Cord Inspect for nicks, cuts, bite marks, etc. Sacrifi cial Anode Varies based on water type and use Electrolysis Kit Varies based on water type and use Not applicable to all units.
  • Page 9: Parts & Accessories

    Ice Eater Parts & Accessories PART PRODUCT PART PRODUCT NUMBER DESCRIPTION NUMBER DESCRIPTION 20002 Propeller - fi ts F250 & P250 Screen Kit 24400 Small - fi ts P500 24500 Large - fi ts P750, P1000 20006 Propeller - fi ts P500 Ice Eater Sacrifi...
  • Page 10: 3-Year Limited Warranty

    Power House electrolysis kit must be mounted to the stainless steel canister. The Power House, Inc. will replace free of charge any defective part covered by this warranty within three (3) years from the date of manufacture (if the unit is used for purposes other than de-icing, then a one-year limited warranty shall apply).
  • Page 11: Service & Repair Contact Form

    Service and repairs returned should include the motor assembly and power cord when possible. • It is the responsibility of the customer to ship and pay freight to The Power House, Inc. or an authorized service center. We accept shipments from Fed Ex, UPS, and USPS.
  • Page 12: Warranty Registration & Warranty Claim Procedure

    6. Ship to: Attn: Service Center The Power House, Inc., 10233 S Dolfi eld Rd, Owings Mills, MD 21117 (Any shipping method for the return of the unit to The Power House, Inc. or an authorized service center is at the customer’s expense.)

Table of Contents

Save PDF