1. Manuals
  2. Brands
  3. AMobile Manuals
  4. Touch Panel
  5. IOT-800
  6. User manual

AMobile IOT-800 User Manual

8" risc-based panel pc
Hide thumbs Also See for IOT-800:

Advertisement

Table of Contents

IOT-800
8" Risc-based Panel PC
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IOT-800 and is the answer not in the manual?

Questions and answers

Related Manuals for AMobile IOT-800

Summary of Contents for AMobile IOT-800

  • Page 1 IOT-800 8" Risc-based Panel PC User Manual...

  • Page 2: Copyright Notice

    Version 1.0 Copyright Notice Copyright © 2015 Amobile Intelligent Corp. All Rights Reserved. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer.
  • Page 3 Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
  • Page 4 12V~24V auto-detection microSD card slot Wi-Fi / Bluetooth antenna connector Micro SIM (3FF) slot 3G/4G antenna connector* UART Connector VESA 75 mounting holes (M3 size) *3G, 4G and NFC are optional modules and your IOT-800 may not come with these components.
  • Page 5 Push the card into the slot until it locks into place. 3G/4G Antenna Connection According to the type of mobile network supported by your IOT-800, attach appropriate antenna to the IOT-800. To use 3G mobile network, attach one To use 4G mobile network, attach 3G antenna as shown below.
  • Page 6 Power Connection The IOT-800 comes with one 2-pin DC terminal block connector to connect power to DC power connector on the device. To use the block connector: Use a wire-stripping tool to strip both of the wires from the DC-input power source.
  • Page 7 Connector Pinouts PWPIN Description: Power Input Connector Connector Type: 2-pin Terminal Block Pin Description Power_GND +12V- GPIO and CAN Bus Description Digital General Purpose Signal Input/Output and CAN Connector Type: 4x 3.3V Digital GPIO connector and 1 x CAN 2.0b Bus Pin Description Description IO_GND...
  • Page 8 Warning： This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Table of Contents